Question about Teac Audio Players & Recorders

Open Question

Where can I purchase Solenoid for Teac Model A-4010 S Reel to Reel Tape deck

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 319 Answers

SOURCE: How to change belt in teac x1000r reel to reel tape deck

If you are not familiar with such work, I don't recommend trying to install belt(s). Replacing belts may involve disassembly of mechanism parts and critical adjustments to follow. Take to a pro/tech

Posted on Apr 23, 2008

Ad
  • 1 Answer

SOURCE: TEAC X1000R Stereo Tape Desk (reel to reel)

usually its a capstan drive belt. $10-18 for the belt & 30mins repair time - you'll be up &brunnin b4 you know it bigmattt@gmail.com

Posted on Jun 20, 2008

robotek
  • 1512 Answers

SOURCE: TEAC reel to reel tape player

Hi jvanheul

You can get a belt kit from these guys for 15 plus some post. Fresh belts, good service Bob will help you out. Cheers. A FixYa for this would make my day :)

regards
robotek

Posted on Jul 19, 2008

  • 4 Answers

SOURCE: Nakamichi BX-2 Cassette Deck Takeup Reel

I had sorta the same problem and I just fixed it. Mine was making clicking noises and jerking the tape causing speed variations and pitch changes, Uggghh. The FF, Rew, and take up functions are not belt driven like most decks. There is a little idler wheel between the motor and the take up axle. Take the whole transport assembly loose from the front of the deck...slide it back 3 inches . Take off the ground wire screw, and 3 screws holding the transport mechanism in place :...1 screw on top, 2 on bottom. Take the black front faceplate off of the drive...2 little screws. This exposes everything.The little idler wheel has a press on tiny,tiny piece of clear plastic holding it onto its little axle. Be hella careful. Use a tiny eyeglass screwdriver to pry it up and off. Dont lose it. Pull the idler wheel off. The rubber has hardened and slips. Pry the rubber rim off of the white plastic pulley using the tiny screwdriver. Put on an O ring that just fits. Scruff up the perimeter of the O ring with 220 sandpaper, Easy does it. Idler wheel goes back in, press on the little plastic retainer, put the black metal plate back on( 2 screws at top), slide the transport mechanism back into the front panel, secure with 3 screws, ground strap, replace cover. Clean heads, demagnetise, badda bing, badda boom.

Posted on Aug 31, 2009

Grubhead
  • 5699 Answers

SOURCE: akai gx-625 reel to reel tape deck has no sound

This could be a head fault? Another possibilty is the preamp stage. You will need to look for something that would take out both channels. Such as an IC.

Posted on Sep 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why does tape go slow, then stops?


Gary hi! I am not sure whether your machine is solenoid controlled but if it is then I would suspect the solenoid that operate the capstan roller to be overheating, I had the very same problem with my Studer and Revoxes and when I smeared some heat sink compound (Available from electronic stores selling components like Radio Shack etc.) and fit if the chassis is cast aluminium like the better manufacturers use,as a heat sink. You can chech the belts and the lubrication of the drive system but I doubt that. Clean the capstan roller with denatured alcohol or cleaning alcohol.

Nov 11, 2014 | Audio Players & Recorders

1 Answer

Will teac rc-120 remote work with teac a-3440


No. It requires a newer type of the RC90 or RC70 models with 12 pin rectangular plug

May 03, 2014 | Audio Players & Recorders

2 Answers

FF problem on Teac Reel to Reel


You need new brake pads installed as the ones in there now are dried up and may have fallen off. This is very common with older decks or 30-40 years old.
I am still working on these decks at Skywave Tape Deck Repair in the Chicago area.

Jul 15, 2013 | Teac Audio Players & Recorders

1 Answer

Teac A-7010 take up reel not pulling


If this is a direct drive deck, the takeup reel motor may be ng

Jul 04, 2012 | Teac Audio Players & Recorders

1 Answer

How do you thread a teac model 40-s tape player


There is no such model.
If you have a A4010S. The tape comes off the reel under the tension arm, over the reverse sensing post, under the heads and lifters, over the
capstan shaft (in between the capstan and Pinch Roller) then under the right tension arm and on to the take-up reel.

Dec 15, 2011 | Teac Audio Players & Recorders

1 Answer

How do I connect a teac ax-20 mixdown panel to a teac a-3340s reel to reel?


It's a 4-in, 2-out panel. Well, you attach up to 4 INPUT channels (labeled plainly on it) and run the two output channels to any two of the the Record In connectors on the Tape Deck.

Sep 11, 2011 | Teac Audio Players & Recorders

2 Answers

My Teac 4070G reel to reel tape deck rewind and fast forward functions work, but the play function does not. Any ideas? Could it be a circuit?


Without actually seeing your Teac reel deck, i suggest you verify that all fuzes in the deck are good..not blown. Also with a tape correctly installed..ensure that left and right tape tension arms are held under tension/ closed by tape tension, also ensure the capstan shaft is rotating... look in back to ensure the capstan drive motor is running.. if yes, and tape still will not play... problem could be a stuck/failed solenoid, dirty or corroded push buttons, or corrosion on contacts where rear circuit boards/plugs insert into other boards.

Feb 28, 2010 | Audio Players & Recorders

1 Answer

Would the owners/service manual for the Teac X-1000R reel to reel tape deck be available for download??


Hi,

You can download the user manual from:

http://safemanuals.com/user-guide-instructions-owner-manual/TEAC/X-1000R-_E

Hope this solves your problem. For more help and clarifications, please reply to this post. Thanks for using FixYa

Jan 08, 2010 | Teac Audio Players & Recorders

2 Answers

TEAC reel to reel tape player


Hi jvanheul

You can get a belt kit from these guys for 15 plus some post. Fresh belts, good service Bob will help you out. Cheers. A FixYa for this would make my day :)

regards
robotek

Jul 18, 2008 | Audio Players & Recorders

Not finding what you are looking for?
Audio Players & Recorders Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Teac Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5699 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

The Knight
The Knight

Level 3 Expert

76140 Answers

Are you a Teac Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...