Question about GE Dishwashers
On ours, the leak was on the right side, and it turned out to be a failure in the seal around the soap dispenser.
Posted on May 04, 2010
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: My ge potscrubber 650 is
Check you filter and screen .Check whether you need an replacement for them.
If you dishwasher has foam coming out from under the door, then the problem is that dish soap somehow ended up in the dishwasher or excessive rinse aid . It is not recommended to prewash the dishes before loading them into the dishwasher as only a small amount of dish soap can cause the sudsing that you experienced. Only detergent specifically designed for automatic dishwashers such as Electrasol®, Cascade® or Cascade Complete® should be used. Spilling rinse aid while filling the dispenser will cause sudsing also.
To clear the suds from the dishwasher sprinkle several tablespoons of non-dairy coffee creamer over the suds. The fat in the creamer will help break down the bubbles. Wait five minutes for the suds to lessen.
Many pump leaks happen around the seal on the pulley. Some pumps have a weep hole that lets water drip out when this seal begins to go bad. The solution is to rebuild or replace the pump.
You'll want to confirm that the fill hoses are connected and properly tightened. Always use new rubber washers when re-installing the hoses. Take care not to over-tighten the connection. Other leaks may be caused by the drain hose being cracked, or by a leaky connection at the water-inlet valve. Too many suds may cause the appearance of a leak when actually it's just a sudsy overflow. Sometimes a drain hose leak occurs at the end of the hose where it attaches to the washer. If the hose is long enough you can cut the leaky end off and re-clamp the hose back on. Usually though, when a hose begins to leak, it is best to just replace the hose.
Posted on Sep 10, 2010
Tips for a great answer:
Jul 14, 2017 | GE Dishwashers
Feb 17, 2015 | GE Dishwashers
Oct 08, 2014 | Dishwashers
Dec 08, 2010 | GE Dishwashers
Sep 10, 2010 | Dishwashers
Aug 14, 2010 | Dishwashers
Aug 09, 2010 | GE GSD4100J Dishwasher
Jan 21, 2010 | GE Dishwashers
Jun 18, 2007 | GE 24 in. GSD2600GBB Built-in Dishwasher
Aug 22, 2019 | GE Dishwashers
Jun 26, 2019 | GE Dishwashers
713 people viewed this question
Usually answered in minutes!