Question about HP LASERJET P1006 Printer
Use Premium paper. It is a little bit more expensive, but it will reduce the amount of jams that occur
Posted on May 31, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: PAPER JAMMED-PRINTER HL5150D
You can clear the jammed paper as follows.
If the jammed paper is removed completely by using the information in the following steps, you can install the paper tray first, and then close the front cover and the printer will resume printing automatically.
If the printer does not start printing automatically, press the Go button. If the printer still does not start printing, please check that all the remaining jammed paper has been removed from the printer. Then try printing again.
To prevent damage to the printer caused by static electricity, do not touch the electrodes shown below.
If you have to pull the paper toward the back of the printer, the fuser may get dirty with toner powder and it may scatter on the next few printouts. Print a few copies of the test page until the scattering of toner stops.
After you have just used the printer, some internal parts of the printer are extremely hot! Wait for the printer to cool down before you touch the internal parts of the printer.
Put the toner cartridge into the drum unit until you hear it lock into place. If you put it in properly, the lock lever will lift automatically.
To avoid print quality problems, DO NOT touch the shaded part shown in the illustration.
If you accidentaly touch the shaded part, wipe the surface with a dry lint-free soft cloth.
Good Luck and don't forget to leave a rating based on my solution:
Posted on Apr 04, 2009
SOURCE: hp p1006 wont load/feed paper
Mine does the same thing. The solution I have used on several occasions is to load it as full of paper as possible without forcing it under the guides. Lift the lid to reset the jam function, then when it begins to try to print, push the top one or two sheets of paper into the printer. If it will grab them and print then it will be ok for the whole stack of paper. Adding more paper before it gets too low also seems to help.
Posted on Jun 05, 2009
SOURCE: paper jam in hp laser 1320
Unplug the power cord and open the cover and remove toner and try to look I inside around the roller and try to manually roll the roller and if you can see the paper try to pull is slowly.
Have a nice day and do not forget to rate please...!
Posted on Feb 10, 2010
Tips for a great answer:
Jul 02, 2015 | HP Office Equipment & Supplies
Jul 21, 2014 | HP Office Equipment & Supplies
Mar 18, 2011 | HP LASERJET P1006 Printer
Feb 17, 2011 | HP Office Equipment & Supplies
Apr 02, 2010 | HP LASERJET P1006 Printer
Oct 01, 2009 | HP LASERJET P1006 Printer
Aug 31, 2009 | HP Office Equipment & Supplies
197 people viewed this question
Usually answered in minutes!