Question about Hotpoint Refrigerators
Proper AIR CIRCULATION is critical to the
proper operation of the unit as a whole...
(I prefer my milk ICY cold... but fluid).
First thing to do is inventory your air vents
inside the FREEZER area... to ASSURE that
NONE are blocked (from open)...
Then inspect the air vent INTO the refrigerator
area that NONE of those are blocked (closed)
Most modern refrigerators give preference
to the milk storage shelf...
(first try a full 3 day DEFROST... (unloaded
with doors wide open... Then set to original settings
(three more days)))...
Only then you are looking at (sorting) a
I use (rather inexpensive) TAYLOR ($6 - USA)
refrigerator thermometers to regulate temperatures...
and STAY AWAY from "adjusting" as much as
Possible... as it can take UP TO 3 days (72 hours)
for the refrigerator to stabilize...
Hope this helps
Carnac the Magnificent
Posted on Jan 29, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Freezer Icing Up
Try contacting the hotline again and ask them if the freezer has a frost sensor on it. If it does, the sensor is not kicking the thermostat to allow for the unit to defrost.
Posted on Oct 21, 2007
bulmer...it takes about two days to fully defrost these units unless you take the freezer section cover off and use a heat source. If you do...be sure to protect yourself against water and electricity mixing....not healthy. See below for another note.
clean the condenser coils below the unit.
check for the amount of gas in the unit. It must be off for half an hour. Remove the back fiber panel. The big thing is the compressor. Clean off the largest pipe coming out of it. Plug the unit in...watch out for the fan! The pipe should frost up and then clear off or stay wet after about 5 minutes. It should not be frosty. If it is, you need refrigerant.
Note: If you do remove the inside freezer panel and defrost, you can see how much refrigerant you have in your unit. Start the unit. Wait 5 minutes and observe the coils. They should be evenly frosted end to end. If approximately so, you're good. If not, you're low on gas.
Posted on Dec 18, 2007
Tips for a great answer:
Jun 17, 2016 | Hotpoint Refrigerators
Jun 03, 2012 | Hotpoint Refrigerators
Dec 14, 2010 | Hotpoint HTS16HBR Top Freezer Refrigerator
Jun 19, 2010 | Freezers
Mar 14, 2010 | Hotpoint Refrigerators
Apr 27, 2009 | Hotpoint RFA60 Bottom Freezer Refrigerator
Jan 29, 2009 | Refrigerators
Jan 10, 2009 | Freezers
Sep 29, 2008 | Refrigerators
Aug 27, 2008 | Refrigerators
33 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: