Questions & Answers for: dm 37

Ad

Question about WD-52525 52" Rear Projection HDTV

2 Answers

...37 = Exhaust or Lamp Ballast Fan stopped 38 = Lamp Temperature High 39 = DMD Temperature High 41 = Short is detected 44 = DVI cable between FMT and Engine disconnected First I would try unpluging the ...

Ad

Question about WS-65313 65" Rear Projection HDTV

2 Answers

37 = Exhaust or Lamp Ballast Fan stopped 38 = Lamp Temperature High 39 = DMD Temperature High 41 = Short is detected 44 = DVI cable between FMT and Engine disconnected Could be a bad solder point that

Ad

Question about WD-52525 52" Rear Projection HDTV

1 Answer

37-38 etc. i have the caps and a general understanding of the removal process, but, again the pcb location?? thank you for any assistance Good day, steve sc; The DM board is normanlly on the left side

Question about WD-52525 52" Rear Projection HDTV

2 Answers

...DM fan failed. (73'' only) 36 Lamp ballast fan failed. 37 Engine (DLP) fan failed. 38 Lamp temperature abnormally high. 39 DMD temperature abnormally high. 42 Lamp fan failed. 44 Check for ...

Question about VOJ370F 37 in. LCD TV

1 Answer

...and the screen went dark. Turns on but there is no image and wont turn off. a capacitor on the DM or convergance board has fried and will need to be replaced. You can use a multi-tester or ...

...37'' FLM-3732 LCD. initally picture would show with high pitch screeching sound that would gradually go away. now display shows color bars and a continous screeching sound continiously with no end. i ...

Question about WD-62725 62" Rear Projection HDTV-Ready Television

1 Answer

...DM board and Power Supply. After this the tv worked for a week and then gave the error code 37: lamp or dmd fan. After following the repsir bulletin posted by Mitsubishi I found that the set would ...

Question about AR-407 Copier

1 Answer

37, Drum mark or image density. You can execute 44-6. This should show which is out of range. Pull the drum unit out & clean both sensors. Check that the blade is cleaning from end to end that the

...some answers on the boating forum. http://forums.iboats.com/bayliner-boats-37/?boatid=29 If the bilge pump is bad, you can find some on iboats.com ...

...DM Tech 37" TV is only showing vertical coloured lines over whole screen- no sound either. Comes on as normal for a few seconds, then this occurs. If you wish to get some details; visit the site ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76140 Answers

Ekse

Level 3 Expert

13434 Answers

Cindy Wells

Level 3 Expert

6032 Answers

Are you a Televison & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...