Questions & Answers for: Canon where is the fuser lamp

Ad

Question about NP 6551 Black and White Copier

1 Answer

be a blown thermistor or lamp. Remove fuser assy & check continuity on thermistor & lamps. Lamps must be disconnected to test. Error will have to be reset in service mode after replacing bad component

Ad

...fuser lamp in half!! First error code when I arrived was E002. The fuser lamp was blown in half and black. The thermistor foils were peeling away from the its board. I replaced the lamp and the ...

Ad

...or all three. I don't believe it can be cleared till the problem is fixed. Most of the time you will need to replace the fuser lamp... It's a older copier and the lamp is most likely blown... Good ...

Question about NP 6230 Copier

1 Answer

...problem since it cuts power and switches off automatically E002, fuser is not heating up, you will have to test the fuser lamp/lamps, thermal fuses, and connections. I could also be the

Question about CLC-700 Copier

1 Answer

...off again. Most likely the either the scanning lamp or the fuser lamp circuit has on 'open' in it. Check the fuser lamps to make sure they are not burned out and make sure the thermal fuse it

Question about iR 2016i Black and White Copier

2 Answers

...Fuser temp low. Heat lamp, thermoswitch, thermistor, SSR E001 Fuser temperature too high or shorted thermistor E002 Fuser temperature too low E003 Fuser temperature too low E004 SSR, or lamp reg. ...

Question about imageCLASS D761 Copier

1 Answer

solucionar el error de systema E000 en mi fotocopiadora imageCLASS D761 Problem on Fuser unite. Please check fuser lamp or fuser fuser cover.Check power supply heater fuse.May be problem two things.

Question about imageCLASS D880 All-In-One Laser Printer

3 Answers

...lamp or PCB. Check fuser for jammed paper. Code reset required, Hi, Although resetting your fuser can get you by for the short term - sadly and sooner than later you are going to need to replace the ...

Question about imageCLASS D880 All-In-One Laser Printer

1 Answer

system error E000 Please check fuser thermistor / lamp You need not change entire fuser. check thermistor, thermoswitch, lamp in fuser.

Question about imageRUNNER 5570 Copier

1 Answer

e000001 0010 Fuser temperature failure, possibly fuser lamps or thermistors. Check that there isn't any gunk on thermistor surface, check lamps for continuity. Error needs to be reset before machine ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Canon Office Equipment and Supply Experts

Clive
Clive

Level 3 Expert

4345 Answers

old marine
old marine

Level 3 Expert

2256 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Canon Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...