Questions & Answers for: Dell where is the fuser lamp

Ad

Question about 1600n All-In-One Laser Printer

5 Answers

...fuser unit yet. I amgoing to take a look at the lamp and look for any fuses or even a thermal switch. Any other input would be appreciated. Thanks. the thermal switch on the fuser are damaged. my ...

Ad

Question about 1600n All-In-One Laser Printer

2 Answers

...fuser lamp control circuitry is bad. This can cause the fuser lamp to stay on all the time - which it ISN'T supposed to do. This in turn causes an overheat condition which will burn out the fuser and ...

Ad

Question about 1600n All-In-One Laser Printer

3 Answers

...fuser lamp and put it back in place, it is not heating properly. Sounds like the fuser is not heating up. There's a thermal sensor in it called a thermistor that reads the heat, if it's out of ...

Question about 1815dn All-In-One Laser Printer

2 Answers

...fuser and inspect thermistor, thermostat and heat lamp. Replace broken part. Any heat errors on the Dell1815 is usually a fuser error, replacing the fuser should clear this right up, part # UG297. ...

Question about 1600n All-In-One Laser Printer

1 Answer

...Lamp in the Fuser from the Fuser Control section of the SMPS 2. The temperature of the fuser heat is monitored by a thermistor (mounted on the Fuser) connected to the Main Board. 3. The Main Board ...

fuser roller because normally the printer will shut down if there's not enough heat at the fuser or the lamp is burned out. The fuser is just before the paper exit and has heat warning labels attached

Question about 1815dn All-In-One Laser Printer

2 Answers

fuser and inspect thermistor, thermostat and heat lamp. Replace broken part. Any heat errors on the dell 1815 means the fuser has gone bad. Your best bet is to replace the fuser, part # UG297. Here is

Question about 5330dn Laser Printer

1 Answer

fuser error in dell 5330 dn Replace the fuser lamp and the thermistor.

Question about 1600n All-In-One Laser Printer

1 Answer

It says open heat error and then it turns itself off. We've had it less than 1 year. Disassemble fuser and inspect thermistor, thermostat and heat lamp. Replace broken part.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Dell Office Equipment and Supply Experts

jasbo
jasbo

Level 3 Expert

2239 Answers

The Knight
The Knight

Level 3 Expert

76140 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Dell Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...