Questions & Answers for: Ricoh where is the fuser lamp

Ad

Question about 6513 Copier

1 Answer

...reset it? Did it come right back? Is the fuser warm to the touch? If so it is most likly to be one or both of the termister in the fuser. If it is cold it may be the fuser heatting lamp or thermal ...

Ad

Question about 6513 Copier

1 Answer

Jam

...fuser lamp has a malfunction Fusing unit SCs displayed on the operation panel. The machine is disabled. The user cannot reset the SC. Turn the main power switch off then on before entering SP mode. ...

Ad

Question about Aficio AP3800C Laser Printer

1 Answer

...fuser units to work in the Aust Model? A new thermister? new lamp? cost? etc. Only the lamps, p/n AX430070 (pressure) AX430159 (heat roll) the watts of the lamps are the same, just different voltage, ...

Question about FT5832 Copier

1 Answer

ricoh ft5832 code e5 47 E547 is a level A code (need to do a fuser SP reset, copier is inop) the fuser lamp continuosly stays on. Probably a shorted triac or fuser board problem.

Question about Aficio AP610N Laser Printer

1 Answer

...lamp in fuser. (lamp is good if you get continuity) (lamp is bad if open) 2) Check the thermostat. (thermal control device) (triggers if unit gets too hot) 3) Also check thermistor (monitors temp of ...

Question about Aficio 2022 All-In-One Laser Printer

1 Answer

...= The melting temperature measured by thermistor is less than 71 C The problem lies in the fuser: - Thermistor fuser defective or incorrectly installed - Fuser Lamp failure Solution: Replace ...

Question about Aficio 450 Copier

1 Answer

...fuser lamp & thermal fuse > have you cleaned or replaced the two thermistor's???? If one of them are shorting out, the fuser will never warm up... Have you cheated the front door and look ...

Question about Aficio 2022 All-In-One Laser Printer

1 Answer

...fuser connection *Heat lamp consecutive on error - Check HR thermistors with SP1-106 001 (ctr) and 002 (ends) *Heat lamp consecutive on error - Heat roller lamp defective *Heat lamp consecutive on ...

Question about Aficio 450 Copier

2 Answers

...fuser lamp and or the thermistor, or the thermal fuse. If you can put you hand near, and I did say near, because the fuser is very hot and can burn you, you should feel heat. Use an inferred ...

Question about Aficio Sp C320dn Laser Printer - Color - 1200 X 1200 Dpi Print -

2 Answers

...lamp. Resetting the code: Execute "Fuser SC Reset" with Some (printer models) or "Engine Maintenance Menu" (MF model) to recover the machine after completing the recovery procedure. Otherwise, the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Ricoh Office Equipment and Supply Experts

gggg

Level 3 Expert

904 Answers

Adorjani Laszlo

Level 3 Expert

1316 Answers

quennie732

Level 2 Expert

422 Answers

Are you a Ricoh Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...