Questions & Answers for: where is the fuser lamp Office Equipment & Supplies

Ad

Question about LaserJet 2550n Printer

1 Answer

...off printer, check and reseat fuser. no luck. any suggestions? fuser was not hot... Replace fuser assembly is the fix Normal consumable, the lamp electrics (lamp, thermistor) will have blown. Part ...

Ad

Question about LaserJet 2550n Printer

1 Answer

...lamp in fuser. (lamp is good if you get continuity) (lamp is bad if open) 2) Check the thermostat. (thermal control device) (triggers if unit gets too hot) 3) Also check thermistor (monitors temp of ...

Ad

Question about FS-3900DN Laser Printer

2 Answers

...fuser heater lamp wire The temperature does not reach 100°C/ 212°F after the fuser heater lamp has been turned on continuously for 30 s. 30/31 ppm printer (EUR/USA model): The temperature does not ...

Question about magicolor 2200 DeskLaser Printer

1 Answer

get message of fuser low therm 1F get message of fuser low therm 1F One of the two small thermostats, that are called "snap-action disc thermostats" and control the electricity flow to the fuser lamps

Question about magicolor 2200 DeskLaser Printer

1 Answer

fuser lamp; now to check the exposure lamp, lift the cover press print the scaner lamp should on otherwise this lamp is defected, now to check fuser lamp, you have to removed fuser unit, use ohm meter

Question about FS-1118MFP Laser Printer

1 Answer

...fuser heater lamp wire The temperature does not reach 100°C/212°F after the fuser heater lamp has been turned on continuously for 30 s. The temperature does not rise by 1°C/1.8°F ...

Question about EP1031/1031F CS/PRO Copier

1 Answer

...C 50 on the screen Verify the continuity of the fuser heater lamp.90% the lamp is open.You need change the fuser lamp and the fuser roller(the heater lamp is in the roller and is not

...fuser lamp in the same voltage of the printer. Take off the fuser, disassemble then take off the lamp and connect two wires in each terminal of the lamp (Fuser lamp works on the same voltage as the ...

Question about Aficio AP610N Laser Printer

1 Answer

...lamp in fuser. (lamp is good if you get continuity) (lamp is bad if open) 2) Check the thermostat. (thermal control device) (triggers if unit gets too hot) 3) Also check thermistor (monitors temp of ...

Question about FS-2000D Laser Printer

1 Answer

...fuser heater lamp wire 30 ppm model: The temperature does not rise 1×C after the fuser heater lamp has been turned on continuously 5 s. 35/45 ppm models: The temperature does not rise 1°C ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...