Questions & Answers for: Kyocera FS where is the fuser lamp

Ad

Question about FS-3900DN Laser Printer

2 Answers

...fuser heater lamp wire The temperature does not reach 100°C/ 212°F after the fuser heater lamp has been turned on continuously for 30 s. 30/31 ppm printer (EUR/USA model): The temperature does not ...

Ad

...buy a new fuser... but it should take... it just takes a little experimentation... This is a fuser fault, blown lamp, blown thermal fuse or a faulty thermistor. The fuser unit needs to be ...

Ad

Question about FS-2000D Laser Printer

2 Answers

...help me! Thank you in advance! This seems to be a fuser error. You need to take it to your local sevice agent for repairs. Fuser problem, you shall change fures termistor or lamp or both..Good ...

Question about FS-1118MFP Laser Printer

1 Answer

...fuser heater lamp wire The temperature does not reach 100°C/212°F after the fuser heater lamp has been turned on continuously for 30 s. The temperature does not rise by 1°C/1.8°F ...

Question about FS-1016 Printer

1 Answer

...fuser thermistor. - Broken thermal cutout or heater lamp. - Defective engine/high voltage PWB. Follow the flow chart: Turn power switch off, and remove power cord. Detach YC7 connector on the ...

Question about FS-2000D Laser Printer

1 Answer

...fuser heater lamp wire 30 ppm model: The temperature does not rise 1×C after the fuser heater lamp has been turned on continuously 5 s. 35/45 ppm models: The temperature does not rise 1°C ...

Question about FS-1016 Printer

2 Answers

...fuser thermistor. 2. Broken thermal cutout or heater lamp. 3. Defective engine/high voltage PWB. Turn power switch off, and remove power cord. Detach YC7 connector on the engine/high voltage PWB. ...

Question about FS-2000D Laser Printer

3 Answers

...ERROR WILL DISAPPEAR TRUST ME Try this: Key in 10871087 163 start execute start cycle power This will reset the code. If the code appears again you will need either a new fuser lamp or

Question about FS-1118MFP Laser Printer

1 Answer

...to change the toner kit (catridge). The error C-6000 refers to the fuser unit. You have to remove the fuser unit and check if the heater lamp and/or the thermistor and/or the thermostat are

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...