Questions & Answers for: Ricoh Aficio where is the fuser lamp

Ad

Question about Aficio CL7000 Laser Printer

1 Answer

...work That's a fuser warm up error. Likely either a blown fuse, lamp or thermistor. Fuser is usually replaced as an assembly, and code can only be reset in "service mode" after the cause is

Ad

Question about Aficio AP3800C Laser Printer

1 Answer

...fuser units to work in the Aust Model? A new thermister? new lamp? cost? etc. Only the lamps, p/n AX430070 (pressure) AX430159 (heat roll) the watts of the lamps are the same, just different voltage, ...

Ad

Question about Aficio AP610N Laser Printer

1 Answer

...lamp in fuser. (lamp is good if you get continuity) (lamp is bad if open) 2) Check the thermostat. (thermal control device) (triggers if unit gets too hot) 3) Also check thermistor (monitors temp of ...

Question about Aficio 2022 All-In-One Laser Printer

1 Answer

...= The melting temperature measured by thermistor is less than 71 C The problem lies in the fuser: - Thermistor fuser defective or incorrectly installed - Fuser Lamp failure Solution: Replace ...

Question about Aficio 2018D All-In-One Laser Printer

1 Answer

code 551 This is fuser error code. check line voltage, thermistor or the fuser lamp. Ricoh error codes

Question about Aficio AP410N Laser Printer

1 Answer

power sc545 You have a Fuser Lamp over heat. You will need to enter Service Mode and reset the fuser

Question about Aficio 2022 All-In-One Laser Printer

1 Answer

...fuser connection *Heat lamp consecutive on error - Check HR thermistors with SP1-106 001 (ctr) and 002 (ends) *Heat lamp consecutive on error - Heat roller lamp defective *Heat lamp consecutive on ...

Question about Aficio SP C820DN Laser Printer

1 Answer

what is sc 565 on a sp c820 SC565 *Heat lamp consecutive on error - Broken main fuser connection - Check HR thermistors - Heat roller lamp defective - Power Supply defective

Question about Aficio SP 3510DN - Printer - B/W - duplex - laser - Legal, A4 -

1 Answer

...you see the lamp come on then you may just have to clean off the thermistors .. open the fuser up with the top screws and check that there isn't any build up of toner on thermistors.. hope this ...

Question about Aficio SP 3510DN - Printer - B/W - duplex - laser - Legal, A4 -

1 Answer

fuser or replace items that cause problem could be thermistor needs to be replace to over temp sensor is bad and needs to be replace or lamp. Once replace then you can clear code. You can buy. Service

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...