Questions & Answers for: image drum sensor

Ad

Question about C5100n Laser Printer

1 Answer

...image drum I have relpaced the black drum but the message order K image drum constantly runs across the screen. what does this mean? The K drum sensor is probably covered with toner residue. First ...

Ad

...what will i do to fix it? There is a sensor by the drum that checks the image on the drum. If the sensor is dirty, or the image on the drum is too dark, it causes this code. 18002435556 for

Ad

Question about EP1030/1030F CS/PRO Copier

1 Answer

...basicly this sensor looks at the drum and determines thew drums ability to hold toner and image. The sensor could have toner spilled on it or the drum needs to be replaced or the senor has gone ...

Question about AR-405 Printer

1 Answer

...drum base surface with the image density sensor before starting process control. However, a certain output is not obtained by adjusting the sensor gain. Cause Image density sensor defective Check ...

Question about EP1030/1030F CS/PRO Copier

1 Answer

...A sensor that look at the drum and determines ability of the drum to hold toner and image. Open close front door should reset it. If it comes back clean the sensor, Drum may need to be

Question about AR-5320 Black and White Copier

1 Answer

...drum base surface with the image density sensor before starting process control. However, a certain output is not obtained by adjusting the sensor gain. Cause Image density sensor defective Check and ...

Question about imageRUNNER C3200 Copier

1 Answer

...drum unit is not fitted properly, or is faulty. The sample image fails to be drawn in ATR control. There is a fault/open circuit in the SALT sensor. The drum unit is faulty. The ITB has deteriorated. ...

Question about imageRUNNER C3200 Copier

1 Answer

drum image ability. Have to remove the drum section and vacum out the Toner and clean the senor. Worse case is the image contol board that image sensor is on, mite need to be replaced. Not something a

Question about C530DN Led Printer

1 Answer

...Image drum up-down movement position detection error. Is the image drum unit removed and installed smoothly? If yes then re-install it If no then Be sure of the connection of the image drum up-down ...

...Image Drum Up/Down Process is not working properly. The errors are as follows: 140 - Yellow Drum Up/Down error 141 - Magenta Drum Up/Down error 142 - Cyan Drum Up/Down error Solution: 1. Reseat the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

jasbo
jasbo

Level 3 Expert

2239 Answers

Ekse

Level 3 Expert

13434 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...