Questions & Answers for: Kenmore remove base

Ad

...base. remove the 2 clips from the pump, on the front of the motor, and then 2 screws hold 2 clips onto the motor, remove the clips and that will let the motor loose from the transmission plate. this ...

Ad

Question about 23612 Progressive PowerMate Bagged Canister Vacuum

2 Answers

...and detailed cleaning the rubber around the base can also be taken off. The directions indicate it's necessary to put a flat head scewdriver between the bearing and the base to remove the

Ad

Question about 24032\24036 Top Load Washer

1 Answer

...REMOVE THE 2 SCREWS ON TOP DOWN AT THE BASE OF THE CONTROL PANEL, SLIDE IT FORWARD A BIT AND LIFT IT UP IT IS HINGED IN THE REAR. NOW REMOVE THE TWO BRASS LOOKING CLIPS FROM THE TOP AND REMEMBER HOW ...

Question about 24032\24036 Top Load Washer

1 Answer

...base like a conventional base bulb,if its a candelabra base they get stuck in the base from the heat and cold you may need to carefully break lamp and use a needle nose pliers to remove base of ...

Question about 22422 Top Load Washer

1 Answer

...remove the bolt inside the agitator tube. Grasp the agitator under the base and pull the entire base up. You can then clean under the agitator. Not leaving the lid closed when not in use will ...

Question about 24902 Top Load Washer

1 Answer

...remove the base, when you remove the base the back stays connected to the frame. just unplug the machine,remove the end caps on your control panel and remove the screws holding it on, them pull ...

Question about 24902 Top Load Washer

1 Answer

...remove the base of the washer then remove drain pump,motor, it's made of black rubber and two hard white plastic parts,one on your motor and one on your transmission that you can pry off with a ...

Question about 24902 Top Load Washer

1 Answer

...remove the outter base,,,,first unplug machine,then remove the screws on the control panel each end,,some machines you have to remove the panel end caps to get at the screws,,,then pull the panel ...

Question about 24902 Top Load Washer

1 Answer

...remove the 2 gold clips that hold the back to base with a screwdriver,,,then open the lid and grasp the inner edge and pull the back of the base towards you and then lift off,,,,if you look inside ...

Question about 24902 Top Load Washer

1 Answer

base of the machine on both sides and in the front bottom. it was gradual at first now it is leaking much more.. What should I be looking at in order to fix it? The leak is likely coming from a broken

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machine Experts

fordexpert

Level 3 Expert

5692 Answers

Harvey Mahal

Level 2 Expert

39 Answers

Kristen Denison
Kristen Denison

Level 1 Expert

13 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...