Questions & Answers for: Yamaha XS2 set up

Ad

Question about 1972 XS2

1 Answer

...of a problem plug. It is good that you cleaned the carb because that would be my second target. Reset the air and idle screws. IMPORTANT > do not tighten these two screws down. Only screw these in ...

Ad

Question about 1972 XS2

1 Answer

...(clockwise) and from that position turn the adjuster of the air by 3/4 ( counter clockwise) set the idle at 1 then turn the air adjuster slowly (counter clockwise) till it reach the highest ...

Ad

...does not seem to be getting fuel. also what are the ports on the side of the carb supposed to be set at hope someone can help make sure you blow out main and pilot jets in carb preferably with an ...

1989 Zuma, just rebuilt carb to OEM specs, turned air screw to factory setting, Removed gas cap in case not allowing air. Installed new spark plug. Scooter will fire and run for about 20 seconds then ...

...The 72 XS650 uses 34mm OD fork tubes. You can easily get replacements from MikesXS for US$129 a set. They have all of the parts you may need to overhaul the forks. The OEM part number for these

Question about 1972 XS2

1 Answer

i want to set my points on my yamaha xs250 twin do i set my left hand points then four cycles and set the right hand side Your points will fire on the combustion and the exhaust stroke. Motorcycles ...

yamaha 1979 GT 80 won't stay running set float cleaned carb new needle and seat bogs at top end Hi, Anonymous and the usual suspects are: 1. Inlet system air leak. 2. Enrichener valve not seated or ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...