Questions & Answers for: my sub

Ad

Question about Audio Players & Recorders

1 Answer

Pre-out for sub in-op can't get anything from my pre-out for my sub. Sub is toggles "on" in speaker set-up. Any other tricks, or could the pre-out be bad? first make sure the actual sub is powered on

Ad

Question about Rockford Fosgate Car Audio & Video

1 Answer

5 stage band pass sub box, 1 sub stolen, box built to spec subs I had a very exp. comp. spec. box built for 2 older rockford power 12" subs the chrome donut magnet model. This box was specd for these ...

Ad

Question about Sharp Office Equipment & Supplies

2 Answers

...If flashing, developer seal still installed, or toner density sensor/main board problem. EE Sub code EU: undertoned. May be toner density sensor problem or developer unit problem. Sub code

Question about Solo-Baric L7 S15L72 Car Subwoofer

1 Answer

i have 2 kicker l7's 4ohm, how do i wire them down to 2ohm? If the subs are dual 2 ohm voice coils..... For a each sub, connect one of the "+" terminals on the sub to one of the "-" terminals. This ...

Question about Solo-Baric L7 S15L72 Car Subwoofer

1 Answer

subs not working. my sub turns on just fine, connections are fine. when i play music my sub has constant static going through it, thats all you hear. i have the stock bose speakers, kenwood headunit, ...

Question about Emx88s Powered PA Mixer System

1 Answer

Can I plug just one subwoofer into my Yamaha EMX88S? What kind of sub do I need to get for it? Do I need to have 2 subs plugged in for it to sound right? Do I daisy chain the subs with the A15 ...

is the sub out strictly for a powered sub or is there a way to hook up speaker wired subs to that The sub out connection is for powered subs. To use a sub that runs off of the amp power, you'll will ...

Question about VSX-454 Receiver

1 Answer

sub hook up to Receiver How do i hook up a powered sub to my receiver Pioneer VSX-454? The Sub is a Yamaha YST SW205. I know that I'm supposed to use an RCA cable to hook them up from the sub pre-out ...

...shoot a sony sa-wm20 that stopped working I am using the single line input from my receiver to my sub. The SUB from my other system works when it is plugged into this same line so I am pretty sure ...

2 dvcoil 4ohm.subs, need 2 ohm load total for monoblok.amp. how do I wire.it If you run one sub with the DVCs in parallel, you would get 2 ohms. If you run both subs with all DVCs in parallel, you ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5686 Answers

The Knight
The Knight

Level 3 Expert

76100 Answers

Marvin
Marvin

Level 3 Expert

85160 Answers

Are you an Audio Players & Recorders Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...