Questions & Answers for: turn signal flasher wiring

Ad

turn signal switch is what is used to direct that flashing 12 volts to the proper signals. The flasher unit: First wire is a ground. Middle wire is the send to the turn signal switch. The last wire is

Ad

Question about 2003 Intrepid

1 Answer

...a black and yellow wire, a red wire, a dark blue and pink wire, and finally a black wire. To help locate the flasher either turn the turn signal on or apply the hazards and listen for its

Ad

turn signal flasher unit on a 1993 Buick LeSabre. I found the 4-way flasher which is clipped onto a support by the steering column but can't find the turn signal flasher. I bought a new flasher at the

...turn signal switch, where it is connected to either the left or right signal light circuits. The other side of each bulb is connected to ground. When either the turn signal or Hazard switch is turned ...

...turn signal not working; have replaced turn signal switch made sure all wiring connections were good; still no emer. flasher or turn signal working. maybe relay in upper dash? you may have a bad ...

...turn signal or Flasher Turn signals and flasher not working. Replaced Combination Flasher with replacment unit from NAPA. Reconnected battery and turned ig switch, no signal/flasher. Started truck, ...

...turn signal is on. Front right and rear right are on a different circuit than the left front an left rear. Locate the Flasher control module behind dash. With key in RUN position check for pulsing ...

turn signal..flasher replaced. is It the multifunction lever then?? There should be a turn signal flasher and a hazard flasher. They are two different parts. If you replaced the hazard flasher and not

...turn signal switch. And a new flasher relay, just in case your old one got overused! Those little flasher relay cylinders were real cheap back in the day, about $2. It's under the dash around the ...

...turn signal lever switch or the wiring to it is most likely the problem. If one lamp does not work even when a new bulb is installed, but other lamps do, check the wires for cuts or breaks, and check ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5926 Answers

Marvin
Marvin

Level 3 Expert

85161 Answers

1400Slugg

Level 2 Expert

260 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...