Amana Dryers - Recent Questions, Troubleshooting & Support


Means an HEating (heating) error. You may have a burned-out heating element, or an open thermal fuse.

Amana Dryers | Answered on Sep 23, 2019


The currant draw of the unit is higher than the rating of the in line circuit breaker causing it to trip, points to a faulty unit have it repaired.

Amana Dryers | Answered on Sep 15, 2019


If the igniter doesn't glow, then you probably have a bad igniter! You can use an ohmmeter to test it. Unplug the dryer before you start working on it. then take the dryer apart until you can get to the igniter. Unplug the igniter plug, and measure it's resistance. If it's less than 100 ohms, then it is okay, but if it's reading over 1000 ohms (or an open circuit), then it is bad and needs to be replaced.

Amana Dryers | Answered on Sep 02, 2019


E 5 Usually means open fuse. Usually a secondary fuse behind the cover where the Blower is. If you change the fuse and still have no power you have a wire issue. Could be a loose connection, or a wiring shorting out somewhere.
Let's hope the fuse takes care of it. Be sure to unplug it before. Checking anything. 220 volt will hurt you. Hope this helps you..

Amana Dryers | Answered on Aug 21, 2019


The igniter or gas valve could be defective.

Amana Dryers | Answered on Jul 15, 2019


You might need a new display board (electronic timer ). Seems like the timer will not send the message for the dryer to stop when the cloths are dry

Amana NED7200TW... | Answered on Jun 21, 2019


Remove top and front panel on dryer to access drum and replace drive belt. https://www.6ya.com/callphilipforhelp

Amana Dryers | Answered on Jun 12, 2019


Here's a YouTube video describing how to do this.

https://youtu.be/uTJ2umLoaKo

Amana Dryers | Answered on Jun 10, 2019


A repair manual would have to be ordered directly from Amana.

Amana Dryers | Answered on Jun 04, 2019


You need to call customer service or that info. It still should be under warranty, check and if so call for service.

Amana Dryers | Answered on Jun 04, 2019


You did not post the model number but there is a belt that wraps around the drum and there is a pulley that keeps the belt tight. If you turn the drum the wrong way, there is an outstanding chance that the belt has slipped off the pulley and there is a not start switch attached to it. Without the model number, that is all I can say.

Amana Dryers | Answered on May 19, 2019


Did you have a problem restarting the dryer after each use? It could be a bad motor or open contact in the timer.I would also check the wiring harness and the plug going to the motor. Hope this helps

Amana Dryers | Answered on Apr 16, 2019

Not finding what you are looking for?
Amana Logo

1,999 questions posted

Ask a Question

Usually answered in minutes!

Top Amana Dryers Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

jdthefixer

Level 3 Expert

746 Answers

Android Man
Android Man

Level 2 Expert

278 Answers

Are you an Amana Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...