How to replace cam drive on andis super 2 speed
ok you need to take the upper cassing off, remove the hinge assembly and the circuit board now the motor unit should come away from the lower cassing.
remove the clips holding the carbon brushes in place beware there are springs behind these clips, remove the two long black clips holding the front and rear motor frames to the field coil and then pull apart. This will allow access to the armature and then simply unscrew the drive cam.
Totaly dismantle all the parts of your Andis AGC clipper.
on Feb 27, 2016
My toutliner cutting too sharp
Adjust your blade. Remove it from the clipper, and then loosen (don't remove) the two screws that hold the blade and cutting edge together. Use a FLAT surface, like a ceramic sink top or flat piece of tile, and push the cutting edge down and angle the blade with the cutting edge facing the flat surface down to about a 30 to 35 degree angle. Use your thumb to hold in place until you can retighten the screws. Under a light, inspect to see if it is level (it will be noticeable if it isn't) or oil the blade and touch it to a clean dry piece of paper. If it is level, replace the blade on the trimmer, and edge your beard. It should be better than brand new. This also works when it doesnt seem like the blade is cutting sharp anymore. ALWAYS make sure the cutting edge is lower than the blade or you WILL CUT YOURSELF or YOUR CLIENT!
on Jan 16, 2016
Need cord for Andis stylemaster, part #01587
Andis discontinued 01587 in 2013. They're still out there but hard to find.
FOUND 3 detachable #01587 cords mixed in a parts box being sold on eBay from a small mom n pop shop going out of business. Very expensive, but got all 3 in perfect condition, will keep one and sell the other 2 in order to off-set having to buy the whole box.
Andis M, ML, SM, PGM, 2-Wire Detachable Cord
Part # 01587.
Andis Health &...
on Jul 06, 2015
Not finding what you are looking for?