Ariston Technologies Logo

Ariston Technologies Answered Questions & Fixed Issues

Do you work here? Claim your company

  • 31 Products
  • 1K Answers
  • 83K Views

Pump fault or more likely blocked filter try cleaning should reset it self

Ariston... | Answered on May 06, 2019 | 3,388 views


take off top check plug wires at back panel if ok check power past switch if ok check voltage to motor if voltage bad motor

Ariston... | Answered on Apr 30, 2019 | 168 views


If it is a child lock, normally by pressing and holding the Child Lock Button. Sometimes it requires two buttons, from Off, press and hold the On button and the Child Lock button for 6 seconds.

For other lock problems, see the videos

https://www.google.com/search?q=unlock+my+ariston+washing+machine

Ariston... | Answered on Feb 24, 2019 | 56 views


F06: Selector Error
Overhaul CND (selector connector)
Overhaul Selector Connector
Control Selector/CND Continuity
Control Selector Motor
Replace Selector
Replace Card

Dado

Ariston... | Answered on Jan 06, 2019 | 1,027 views


did you check breaker in breaker panel

Ariston... | Answered on Jan 05, 2019 | 52 views


https://www.needapplianceparts.com/aristonerrorcodes.aspx.

Ariston... | Answered on Dec 16, 2018 | 216 views


check belt if ok see if pump is working

Ariston... | Answered on Jun 15, 2018 | 111 views


when I wash heavy stuff it will not spin properly because the weight is not distributed evenly over the load and it stops every time. you may need a repair man unless you can just move the dial to a drain spot rather than spin, if enough water gets out it will probably open then.

Ariston... | Answered on Jun 15, 2018 | 102 views


Has anyone got manual for ariston K-LB 121?

Ariston... | Answered on May 02, 2018 | 99 views


H2O is the symbol for WATER and probably indicates a WATER related fault on your machine. A pressure switch is the normal way the machines 'sense' when the level is sufficient. Overfilling suggests a faulty switch, which will need to be replaced by a technician. Also, ensure that the machine drains as it should, if not, the pump filter may be blocked.

Ariston... | Answered on Apr 04, 2018 | 431 views


the only thing to do is check that the water censor pipe is not blocked preventing the censor to tell the controller its finished the spin cycle this is a small 5mm pipe leading to wards the top of the machine take it off and blow gently down it you will hear a click and one when you release the air this means the censor is working but the small pipe where it came from is blocked clean the blockage with a pipe cleaner or similar replace the pipe eric

Ariston... | Answered on Dec 26, 2017 | 102 views


go online to https://www.manualslib.com/manual/645321/Ariston-Built-In-Oven.html

Ariston... | Answered on Dec 21, 2017 | 499 views


hmm sounds like a spring has busted inside your washer there and the diagnostic computer inside the washer was damaged so its not able to unlock its door....

Ariston... | Answered on Dec 17, 2017 | 149 views


Maybe get a knob type & eliminate this type of problems

Ariston... | Answered on Nov 22, 2017 | 616 views


Before you change fuses, do you have an internal fuse board or RCD system in your home? Sometimes, an individual RCD can trip out, locking off sockets. Some sockets are individually set up for up and downstairs in a house, or different rooms. If you have a board or RCDs, check them out :)

Ariston... | Answered on Nov 18, 2017 | 73 views


if it looks like a big yellow rubber band, it will stretch to fit
being rubber if you heat it up by repeated quick stretching it will be easier to assemble

Ariston... | Answered on Oct 25, 2017 | 187 views


This is normal , it takes small quantity of water unlikes old washing machines

Ariston... | Answered on Oct 04, 2017 | 53 views


Check the screen and the inlet to the pump in the bottom of the washer if it does not empty the water from the wash cycle completely it may not go to the rinse cycle.

Ariston... | Answered on Sep 06, 2017 | 85 views


I'm only guessing here but it's possible the internal thermostat is broken and the oven is overheating {?} and triggering some built in safety switch that turns the oven off so it won't cause any damage.
I suggest you call the company, or a local oven repair person.
Letting us know if it is Gas or Electric may help too.

Ariston... | Answered on Aug 01, 2017 | 68 views

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Ariston Technologies Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Tom Chichester

Level 3 Expert

54195 Answers

Dado

Level 3 Expert

509 Answers

Are you an Ariston Technologies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...