Asko Dryers - Recent Questions, Troubleshooting & Support

I don't know but dryers generally are of a fairly crude construction designed to be cheaply assembled by the manufacturer and not so easy to repair.

The ones I have tackled, the belt replacement entailed removing screws until something important fell off and then on and on until the back of the cabinet could be separated from the front far enough to change the belt...

Asko Dryers | Answered on Oct 11, 2019

You will get a good idea here

Asko Dryers | Answered on Sep 13, 2019

I had the same problem. Turns out the reset button on the back of the dryer needs to be pushed; when you push the reset button you should hear a click. If you do not hear a click the problem was probably not the reset button. The button shuts down the dryer heating elements if they are getting too hot and also keeps the drum from turning unless the start button is held down.

If you push the reset button and the dryer starts to work again, I strongly recommend that you stop the dryer and investigate why the heater elements overheated. In my case there was lint/hair build up on the heater elements themselves. Extensive dryer disassembly is required to properly clean the heating elements but it is worth the prevention of a house fire. While you're at it, clean the rest of the machine and the duct work.

Hope this helps

Asko T700... | Answered on Aug 23, 2019

What is the belt part number for Asko DryerModel # T702C

Asko Dryers | Answered on Jun 27, 2019

If you have a condensate tank that fills up too much the float inside the pump housing will shut the dryer off also.

Asko T721... | Answered on Feb 01, 2019


Asko Dryers | Answered on Dec 01, 2018

Check breaker that’s its not tripped.

Asko Dryers | Answered on Nov 15, 2018

Belt or drum rollers could be worn

Asko Dryers | Answered on Sep 28, 2018

I took the top and back of my unit apart. Then from the back it is still not the eaisiet of tasks.

Asko T712... | Answered on Sep 10, 2018

Look in the centre of the back of the dryer for a black rubber seal and press the seal in until you hear a click (this may not apply to your particular model of ASKO dryer). If you are lucky the circuit breaker has done it's job and saved your dryer, otherwise it has been badly damaged and will need electronic repairs to the control board.

Asko Dryers | Answered on Sep 10, 2018

possible temp sensor fault

Asko T712... | Answered on Jul 15, 2018

Go to and enter 712. With luck, you will be presented with a list of common replacement parts/assemblies and may be able to view a generic Asko video showing disassembly.

Asko Dryers | Answered on Jul 09, 2018

Bad contact on the unit's relay would be my guess, but I don't have a schematic handy to confirm.

Asko Dryers | Answered on Jun 17, 2018

Not finding what you are looking for?
Asko Logo

571 questions posted

Ask a Question

Usually answered in minutes!

Top Asko Dryers Experts


Level 3 Expert

85206 Answers

Mat Kramer
Mat Kramer

Level 1 Expert

19 Answers


Level 3 Expert

13434 Answers

Are you an Asko Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides