Avanti Logo

Avanti Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 477 Products
  • 4K Answers
  • 250K Views

check if you get power by the motor if no power change the thermostat

Avanti WCR683DZD... | Answered on Sep 11, 2019


check the switch at back if it is working, check the motor compresor touch the top of the motor comp, if working, the possible problem is the freon, touch the condenser at the back of the unit if hot the freon is working, if no hot, load a freon, ok

Avanti... | Answered on Jul 24, 2019


Check and clean door sealing area
and door gasket.

Wipe any ice and excess moisture
from chamber.

Check and clean door sealing area
and door gasket

https://www.beckmancoulter.com/wsrportal/techdocs?docname=B10093.pdf

Avanti Washing... | Answered on Jun 26, 2019


My washer is not turning or spinning could someone please help me

Avanti Top Load... | Answered on May 29, 2019


Is compressor continuously running? If so, and not cooling at all, most likely it’s a freon leak or blockage. If compressor is coming on and off every couple minutes, then it could be relay and overload that plugs onto compressor.

Avanti... | Answered on May 09, 2019


If it gets hot and will not start, the first think to check is the capacitor. The capacitor creates a favorable phase shift on the incoming power and it pushes the motor to spin it at the start winding. Without the capacitor, you don't get that push you need and it does what we call in the field "single phasing". While the term single phasing is usually only used in 3 phase power, you can technically single phase a compressor with single phase power if the capacitor fails because you are losing your favorable phase shift causing in to not spin and overheat. I hope I didn't lose you on my explanation, but I want to try to explain it in a way that is understandable.

You'll have a rating on the capacitor that has a number followed by MFD of uf. This is your microfarid number. Your allowed +/- 6% of the rate capacitor number before is is deemed bad.

You'll need to find someone with a meter that reads microfarids to be able to test the capacitor.

Avanti... | Answered on Mar 30, 2019


The simplest solution is to locate the buzzer and disconnect it. There is an 8 second timer that could also be disconnected.

Avanti... | Answered on Mar 07, 2019


Is the motor fan working may be getting too hot. Or you may be able to unplug it for a few minutes then plug it back in.

Avanti WC492D... | Answered on Jan 23, 2019


I had this same issue on this same model (which is how I happened upon this page). I'm still not exactly sure why, but the problem resolved when I pushed down on the knob more firmly than I normally would to light the stove, and it seemed to slide in a little deeper. After that, the oven would light.

Avanti Kitchen... | Answered on Nov 18, 2018


Thermostat problem or air damper problem most likely

Avanti... | Answered on Nov 04, 2018

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Avanti Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Tom Chichester

Level 3 Expert

53725 Answers

ray gallant
ray gallant

Level 3 Expert

63941 Answers

Are you an Avanti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...