Bertazzoni Kitchen Ranges - Recent Questions, Troubleshooting & Support


My handyman just installed an inline dimmer switch on the wire leading to the oven fan. Turned down to halfway, there's now a gentle breeze, rather than a wind, coming from the oven door, and the noise is reduced as well. None of the wires are heating up at all. Seems to be a successful adaptation to an atrociously loud component of this otherwise lovely stove.

Bertazzoni Pro... | Answered on Nov 06, 2019


It's my understanding that when the range encounters an error, it flashed "E" and then the error code. As this occurs E as your turning it off, and not followed by an error code, it mat be a fluke in the design. I'd ask the dealer where you bought it, but if everythng is functioning normally, it's probably nothing of concern.

Bertazzoni... | Answered on Jun 17, 2019


Hi Royce, for the oven temperature issue try to find the owners manual,it will give you information on how to offset the temperature setting so what you set is what you get. Now for the broiler, if it's an electronic ignition (goes click,click,click) the flame sensor might be bad or damaged. In either case call the store you bought it from or the factory authorized service provider. If it's only a month old it will be under warranty. Hope that helps.

Bertazzoni... | Answered on Feb 23, 2019


Hello Mike,

The problem seems to be your thermal-couple safety valve. As when the valve does not get enough heat or has gone bad you have to replace it as the burner will not keep the flame going. If it is newer than two years it should still be under warranty and Bertozzoni will repair by calling 866 905 0010.
However, if it is older than two years there are five therma-couples on this Range I will need to know exactly which burners are working and which are not as to find out the part numbers.

Thank you for chosen FIxya.com

Justin

Bertazzoni... | Answered on Nov 30, 2018


In my case, the igniting wire was too close to another piece of metal. It was igniting upstream from the burner. All I did was push up on the wire, and the broiler started working again!

Bertazzoni... | Answered on Dec 19, 2017


You may need to replace the thermostat/thermocouple. This is a common part that needs replacement every few years (sometimes they just stop working sooner too). It's cheap and relatively easy to change. The purpose of this is to prevent a gas leak (because the oven is turned on) if the flame were to go out and could not be re-lit.

Thermocouple Thermocouples What is thermocouple Types of thermocouples

Bertazzoni Gas... | Answered on Feb 02, 2016


Bertazzoni X366GGVX Stainless Steel Gas Range Remove ...

www.fixya.com > ... > Bertazzoni X366GGVX Stainless Steel Gas Range
Bertazzoni X366GGVX Stainless Steel Gas Range"remove oven door" Questions. Question about Frigidaire Kitchen Ranges. 1 Answer ..

Bertazzoni... | Answered on Oct 04, 2015


try turning the gas up slightly and holding the knob down a few seconds longer after it is alight.

Bertazzoni Gas... | Answered on Mar 05, 2015


Sounds like your switch has gone on the oven.
What oven model make would help.
If its digital it will be expensive.
So much for technology give me an old fashioned manual oven, car , tv anyday...

Bertazzoni... | Answered on Oct 16, 2014

Not finding what you are looking for?
Bertazzoni Logo

62 questions posted

Ask a Question

Usually answered in minutes!

Top Bertazzoni Kitchen Ranges Experts

Dan Connors
Dan Connors

Level 2 Expert

119 Answers

Racki123

Level 1 Expert

33 Answers

Todd B

Level 3 Expert

572 Answers

Are you a Bertazzoni Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...