Car Audio & Video - Recent Questions, Troubleshooting & Support


error occurred. please turn off,then turn on again

Panasonic... | Answered 2 hours ago


Need pin for#1

Car Audio &... | Answered 5 hours ago


When you disconnect your battery and then reconnect it again, it disables the radio. This is an anti-theft protection for your car radio.
The enable your radio the activation code is in your vehicle owner's manual. If you do not have this code you need to go to your Ford service centre and get them to enter this code for you.

Car Audio &... | Answered 16 hours ago


Error occurred please turn unit off then turn on again in mdh1

Panasonic... | Answered 23 hours ago


Double check your connections. Sounds like you are picking up alternator whine. Make sure the rca cable is at least 12" away from power and remote cables when installing fem radio towards amp. Its best to runthem on opposite sides.
.A thumbs up would be greatly appreciated if this answer is helpful to you. lanser-4000-outputting-loud-engine-noise-shonxoarcym4awy4zl1imx4o-2-0.jpg

Lanzar MXA282... | Answered Yesterday


there is no reset button, the reset is to disconnect power to the unit and see if it starts up ok, you do say problem but if it is loading problem then resetting it will not fix it.

Kenwood KDC-C719... | Answered Yesterday


Hi Mark,
Here is a direct link to Tatung http://www.tatungusa.com/Home

Car Audio &... | Answered 2 days ago


Hello Brian,
There is no reboot button on this unit. To reboot the receiver, simply unplug AC power for 30 minutes, then while plugging back in press and hold the power button for 5-10 seconds at the same time to reset.
Check all the speaker wiring for shorts, make sure they're also not touching the chassis of the receiver, or are not otherwise pinched or frayed. If all looks well, try disconnecting all the speakers and cycle the power off, then on again.
Try connecting the speakers one at a time until one of them shuts the Audio down. Check this speaker with a multi-meter and make sure it is reading between 4-8 ohms.
If not, the speaker may be blown and is causing the receiver to short out and therefore power the audio down.
If you still cannot get any audio through the system, then it likely has bad output transistors, or capacitor and is in need of service.
Here is a link to the Operating Manual Good Luck, JP https://www.manualslib.com/manual/286996/Kenwood-107vr.html

Kenwood Car... | Answered 2 days ago


red-accessory
yellow-constant
blue/white-pwr contd
blk- ground
blue-antenna power
grn-left rear -positive
grn/blk -negative
purple-right rear-positive
purple/blk-right rear=negative
white-left front-positive
white/blk-left front-ft negative
gray-right front-positive
gray/blk=right front

JVC Car Audio &... | Answered 2 days ago


your accessory power for the radio is on the wrong circuit,wish the red wire of the radio

JVC AM FM CD DET... | Answered 2 days ago


you need the jvc cable compatable for that unit

JVC KD-G421 CD... | Answered 2 days ago

Not finding what you are looking for?
Car Audio & Video Logo

108,003 questions posted

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5013 Answers

Marvin
Marvin

Level 3 Expert

85020 Answers

The Knight
The Knight

Level 3 Expert

76060 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...