Dishwashers - Page 6 - Recent Questions, Troubleshooting & Support


perhaps if we knew the MAKE .information could be found

Dishwashers | Answered on Jun 04, 2019


Your water will not get hot because your control board since there is no water been coming into the dishwasher and turn the heater off you need to run the diagnostic mode fix the problem and that should take care of the issue

Whirlpool... | Answered on Jun 04, 2019


First we need to know what brand we dealing with and usually the light flush so many times and repeats it self again count how many times it flashes that would be your error code message

Bush Dishwashers | Answered on Jun 04, 2019


Select improper detergent

Dishwashers | Answered on Jun 02, 2019


SORRY WE DO NOT KNOW THE MAKE OF IT.

Dishwashers | Answered on Jun 02, 2019


Just had the same problem, removed the excess water from the drawers, turned off the power, removed the bottom drawer by pushing in the lugs at the bottom of the drawer where it butts up to the drawer front and pulling out the drawer. Then had to mop up with 4 t-towels and half a roll of kitchen roll the water in the bottom of the machine housing. The water gets into the electronics at the rear of the housing and obviously warns you of this by the F1 code?. I removed the white cover over the electronics with a screwdriver by pushing it into a slot then sliding the cover across to the right, it is indicated on the cover how to remove it. I also then removed the screw on top of the PCB (printed circuit board) and lifted up the grey plastic base and wiped under that and the under side of the PCB. The PCB unclips on the left hand end of it and lifts out, try not to pull the cables out though. I then used a hair dryer as suggested by someone else on here to dry out any excess that you could not wipe dry, my daughters Hello Kitty hair dryer didn't last long though, she's not impressed! So try not to stick the dryer right in the housing to avoid overheating it. About 5 minutes did the trick for me, then re-assembled everything, turned it on and hey presto! It worked!!!! Its not that hard, good luck!!!

Fisher and... | Answered on Jun 01, 2019


Could pump or controller failure

Samsung... | Answered on Jun 01, 2019


Probably pump failure. The debris may have jammed it.

Dishwashers | Answered on Jun 01, 2019

Not finding what you are looking for?
Dishwashers Logo

90,407 questions posted

Ask a Question

Usually answered in minutes!

Top Dishwashers Experts

Marvin
Marvin

Level 3 Expert

84966 Answers

Brad Brown

Level 3 Expert

18060 Answers

Cindy Wells

Level 3 Expert

5909 Answers

Are you a Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...