Office Equipment & Supplies - Page 9 - Recent Questions, Troubleshooting & Support


May be jammed up with crud. Take it apart and clean the guts thoroughly.

Office Equipment... | Answered 2 days ago


HiTi has discontinued this printer. You can find drivers for Windows XP here (file download). I found the driver on this site. The driver may be compatible.

This site claims to have a driver for Windows 7 X64.

Hi-Touch Imaging... | Answered 2 days ago


To do an NVRAM reset follow these steps:

1. Turn off the printer.
2. Hold down the Cancel button and the right arrow button and while holding them turn on the power.
3. Wait for the message Permanent storage unit. Then release the buttons.

Wait for about 2 min. When the printer is back at the ready screen it has been reset.

Warning:
it will reset EVERYTHING, including your serial number and everything else that matters.

Thanks for using fixya...

HP Laserjet... | Answered 2 days ago


CD 010 is unformatted hard drive

CD030 is admin data not on hDD

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Konica Minolta... | Answered 2 days ago


Follow the steps given below to reset Epson L382 printer.
Step 1: Turn the printer off.
Step 2: Press and hold the reset button which is on the back of the printer using a paper clip or tip of a pen.
Step 3: Turn on the printer by holding the Power & reset button and continue to hold both the buttons.
Step 4: Wait for 5 seconds and a warning sheet will print. Release the reset button.
Step 5: After 5 seconds, another sheet will print which will show the IP address of the printer.

hold the reset button which is on the back of the printer using a paper clip or tip of a pen.

WHERE IS RESET BUTON? I CANT FIND IT.

Epson Office... | Answered 2 days ago


Turn off, remove print wheel, turn on, turn off, reinstall print wheel, turn on. Make sure PROPORTIONAL SPACING is not selected.

IBM Office... | Answered 2 days ago


Look for a thin mylar strip running behind the printheads which should be sitting in a little guide tab, but has probably fallen out. Put the mylar strip back in place. Recommended by Canon support, one poster reports permanent resolution of the problem. The Canon tech said he gets about three calls a week for this problem.

Canon Office... | Answered 2 days ago


sir I am using Tally 7.2 and now some days before and error occur while doing entries. Now my 3 companies are not opening as the data is available in tally folder. Please Help

Office Equipment... | Answered 2 days ago

Not finding what you are looking for?
Office Equipment & Supplies Logo

591,566 questions posted

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

k24674

Level 3 Expert

8081 Answers

Cindy Wells

Level 3 Expert

5909 Answers

Marvin
Marvin

Level 3 Expert

85020 Answers

Are you an Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...