Ovens - Recent Questions, Troubleshooting & Support


What device are you talking about?

Ovens | Answered 5 hours ago


Try it on broil. If it still does not heat, replace the element.

Ovens | Answered 5 hours ago


This is a very expensive commercial oven. I would strongly suggest that you do not try and service it yourself.

i have just had one installed and with running power, water and drainage, it was $40K.

Ovens | Answered 11 hours ago


Check in your owners manual, if you don't have the manual, take the bulb out and bring it with you. Usually it will take an appliance bulb. You can ask for this where you buy your bulbs

Ovens | Answered 16 hours ago


Make sure you hit the reset switch first... on top of the lower over... behind the panel...they trip easy and "kill" the oven.

Thermador SC302T... | Answered Yesterday


Based on your description I believe you are hearing one of the elements vibrating as it heats up. As the voltage is supplied to the designated heating element vibration can occur if the element is slightly uneven in its cradle. If you are going to attempt to check the cradle for looseness please turn off the breaker to the unit before doing so. Check the feet on the lower unit and the hanging brackets on upper broiler if so equipped. There are some screws at the back that attach the elements check for tightness and alignment of the bracket. Sometimes people lift the element up to clean under it and it does not seat properly.
If you are in anyway not comfortable or don't find the cause, call a qualified tech.
Repeat....turn off breaker to the unit.

Hope this helps.
Best to you.

Ovens | Answered 2 days ago


Gave up and bought a new timer module for £66 from espares. Timer board has microscopic components so even if you knew what was wrong it wouldn't be fixable.

Zanussi ZBF360... | Answered 2 days ago


According to the convection fan which does not work, I suggest checking the main oven selector, wiring and convection fan.
According to the timer you should first set the time and then verify the correctness the timer relay. If relay is open than completely oven will not work.

25855965-cqik0gnotbvxzf0n00pcjb1b-1-0.jpg
25855965-cqik0gnotbvxzf0n00pcjb1b-1-1.jpg

Dado

Electrolux Ovens | Answered 2 days ago


The problem is most likely with the Large Rectangle Grey X2 Capacitor on the clock circuit board which needs to be replaced by an appliance repair person or electrician.

From my understanding, although they are self-healing, as they are subjected to power surges they deteriorate and allow less and less current through the circuit until they get to a point where there isn't enough current flowing to firmly latch the relay (which is why there is a buzzing from the relay turning on and off quickly).

My clock was also at the point where there wasn't enough power for the timer beeper, so when the beeper went off it would reset the clock after about half a beep. And if the clock was started at 12:00, when it got to 16:08 it would reset as there wasn't enough power to display all those led segments.

I replaced the 1000uF capacitor, which didn't change anything, then replaced the X2 capacitor and now it works perfectly!

Hopefully that is helpful to someone. :)

Zanussi Ovens | Answered 2 days ago

Not finding what you are looking for?
Ovens Logo

53,823 questions posted

Ask a Question

Usually answered in minutes!

Top Ovens Experts

Marvin
Marvin

Level 3 Expert

83850 Answers

Sal De

Level 3 Expert

2699 Answers

Craig Butler
Craig Butler

Level 3 Expert

1730 Answers

Are you an Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...