Refrigerators - Page 2 - Recent Questions, Troubleshooting & Support

Evaporator (cooling coil) fan motor is not operating or a component failure in the defrost system which comprises the defrost timer, defrost heater, or the defrost safety termination thermostat.

Refrigerators | Answered 17 hours ago

Hi, if there are no screws in the underside of the bottom edge of the control panel, you should see two little lots in the underside of the bottom edge. Just use a flat blade screw driver and insert it into the slot. Twist the screws driver and the control panel should release.
I hope this helps you. please let me know if I can assist you further.


Refrigerators | Answered 20 hours ago

Tap to view the compressor. Do you feel it works?
Good luck.

LG Refrigerators | Answered Yesterday

Most likely doesn’t have one. Check owners manual

Refrigerators | Answered Yesterday

If you have an icemaker and water dispensor that is connected to the house water line, you need to locate that line and shut if off at the connection. The water might be from the defrost cycle that the unit uses though. If it is not appearing all the time, appears to be dirty or a fixed size puddle, the issue is with the defroster and not the water dispensor.

LG Refrigerators | Answered Yesterday

Look at for a parts list if your model # is correct

GE Refrigerators | Answered Yesterday

It there are no trim pieces covering screws, Pull up hard and fast on handle to remove it. Then tighten posts that handle attaches to

Kenmore... | Answered Yesterday

Some have set screws on back side of handle. Others handle comes off 1st by pulling up hard and fast. Then posts that handle fasten to can be tightened

Whirlpool... | Answered Yesterday

Request the wiring diagram from Bosch if there isn't one pasted on the rear.

Bosch... | Answered Yesterday

There should be one on machine somewhere. Maybe in console area or inside bottom kick plate or inside cabinet.

Whirlpool... | Answered Yesterday

In my opinion, advices from will help you to find a job. I had such experience when I was a student

Culligan... | Answered Yesterday

Quite possibly. where was it located when you took the board out?

Refrigerators | Answered Yesterday

Check to see if the bale is caught on an ice cube. The bale senses the level of ice cubes in the bin. Sometimes an ice cube will get stuck, keeping the bale up which stops the whole ice making process. Sometimes this will cause the water feed to freeze. If you can get at any of the tube to feel if it is frozen (crunchy ice inside) hit it with a not-too-hot hair dryer.

GE Refrigerators | Answered 2 days ago

Not finding what you are looking for?
Refrigerators Logo

171,196 questions posted

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4655 Answers


Level 3 Expert

83850 Answers

Brad Brown

Level 3 Expert

17816 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides