Saws - Recent Questions, Troubleshooting & Support

Take this with a grain of salt, but I think the brushes usually come out with a slug with a place for a LARGE flat screwdriver to unscrew them. Usually the brushes just pop out then, and you can put in new ones. I may have misread the question...
As far as pay; some people work with fixya for a living, but part of that contract is that they can't even confirm that they are paid, let alone tell you how much. If you try to drag that information out of somebody on here, you are asking them to ruin their livlihood.

Saws | Answered Yesterday

If you measure the voltage with a multi meter, you don't get the voltage appropriate to run the unit, That's mean the battery is bad, and it is not receiving charge. The battery needs to be replaced with brand new one. Thanks

Saws | Answered 2 days ago

HIt the reset button. If that doesn't work, take the motor off and vaccuum the hell out of the brushes and just clean it of sawdust. Then try it again.

Saws | Answered 2 days ago

Here is a site that may have the manual you are looking for

Saws | Answered 3 days ago

Unplug the saw, look for the bolt in the center of the blade and also look for the arbor lock button, if there is no button on the motor, look for the jamb nut on the back side of the blade holder, if there is none you can use a block of wood under the blade for the teeth to bite into. Unscrew the bolt and it may be reverse thread! Remove the blade and the collar, put the new blade and collar on and tighten.

Dewalt Saws | Answered on Mar 14, 2019

Can you send a larger picture of data plat? Also what voltage are you wanting to run saw on, 115 or 120 volts single phase. I found wiring but the last letters are a little different.. I will try to help you wire this.

Saws | Answered on Mar 13, 2019

Most Stihl machines use 0.5mm spark gap

Stihl Saws | Answered on Mar 13, 2019

You have tripped the overload switch. It should reset after it cools off. If it does not then there may be a small button, like on the bottom of a garbage disposal. Good Luck!

Dewalt DW746X... | Answered on Mar 13, 2019

From Hi kaqibso these saws are equipt with a decompression switch.It is located on the right side of the unit and has a red cap on it, pull out on it. Best of Luck......

Stihl Concrete... | Answered on Mar 13, 2019

check on the back of the motor housing

Makita Saws | Answered on Mar 12, 2019

Not finding what you are looking for?
Saws Logo

15,749 questions posted

Ask a Question

Usually answered in minutes!

Top Saws Experts

Tom Chichester

Level 3 Expert

50916 Answers

ray gallant

Level 3 Expert

60310 Answers

Pieter Vleeshouwers
Pieter Vleeshouwers

Level 3 Expert

2004 Answers

Are you a Saw Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides