Washing Machines - Recent Questions, Troubleshooting & Support


E20 is an error code for drainage failure. Check where the appliance drain hose connects to the house drains for a blockage.

Washing Machines | Answered 47 minutes ago


Most US-sold washers made after the mid 1980s don't have lint filters. The manufacturers weasel-word around it by saying that the lint "goes down the drain", leading people to optimistically assume that there is a self-cleaning filter in there somewhere. There usually isn't and whatever lint doesn't go down the drain is filtered by your cloths (but whatever does might clog your septic system). As a result of this scam, it's much harder to hang-dry or iron-dry clothes that haven't been hand washed. And, if you think spending $2000 on a pair of matched "front-load" style machines will solve this, you might be wrong; many of those washers still have no lint filter.

GE WBSR3140DW... | Answered 3 hours ago


RUN IT WITH JUST WATER AND BLEACH ONCE IN AWHILE NO CLOTHES

Washing Machines | Answered 5 hours ago


You machine may have lost a spring. I would recommend removing the back and place all bolts in a cup. Do not forget to unplug first. Then take a look at any thing out of place.

Simpson Washing... | Answered 12 hours ago


It depends on the reason for the hot smell - discovering this would mean a trip to the service shop and weighing the cost of that against a replacement microwave.

Unless your Hotpoint is something special, it is likely a replacement would make sense.

It is wise to periodically measure the power output of a microwave oven by timing the boiling of a measured quantity of water when it is young. When or if the time has extended more than about 10% it is time to think about service or replacement. It is also important to keep the inside of the cabinet clean and all the air vents clear.

Hotpoint Washing... | Answered 14 hours ago


I am not familiar with the model but it is a fairly general design practice to fit the pump under the wash tub and access is from underneath or the rear. Sometimes the machine must be laid down or turned upside-down for access though it is best to positively identify the leak site first using a mirror and strong light, a camera or whatever it takes...

Washing Machines | Answered 16 hours ago


Water Temperature Sensor Error - Check the Water Temperature Sensor,Heating Element and Element Relay.
If during the water heating step in wash cycle,the water temperature sensor(NTC) value is out of range,or the heating element circuit has failed,the F05 error code will be displayed - Check connections to
the Sensor,Heating Element and Relay.

Whirlpool Duet... | Answered 16 hours ago

Not finding what you are looking for?
Washing Machines Logo

256,062 questions posted

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Brad Brown

Level 3 Expert

18002 Answers

paul
paul

Level 3 Expert

825 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...