Cadillac Logo

Cadillac Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 410 Products
  • 124K Answers

Cover the TV receiving area that receives the remote control signal and cover that from receiving any signals and see if the problem still exists

Cadillac... | Answered 8 hours ago

Data link connector fuse should be number 27 and driver side fuse box at the end of the left side of the dash.

Cadillac... | Answered Yesterday

Behind and above glove box on passenger side.

1997 Cadillac... | Answered Yesterday

If it is receiving power. it has to be set.

Cadillac Cars &... | Answered Yesterday

There is a module that controls the speed of the fuel pump. It uses computer signals to control output of fuel flow. The new cars do not use fuel pumps that run at only one speed

Cadillac Cars &... | Answered on Sep 15, 2019

DTC P0016: Crankshaft Position (CKP) - Intake Camshaft Position (CMP) Correlation Bank 1
DTC P0017: Crankshaft Position (CKP) - Exhaust Camshaft Position (CMP) Correlation Bank 1

• An actuator that is in the full advance or retard position can cause this DTC to set.
• The presence of DTCs P0008 and P0009 along with P0016, P0017, P0018, and P0019 indicates a possible condition with the primary timing chain and the alignment between both intermediate sprockets and the crankshaft. Or, the crankshaft reluctor wheel has moved and is no longer referenced to top dead center (TDC).
• Observing the desired and actual camshaft angle parameters, with a scan tool before a DTC sets, may help to isolate whether a condition is specific to one camshaft, one bank, or caused by a condition with the primary crankshaft timing.

Now do you want to change a sensor an have it not fix the problem .

Cadillac Cars &... | Answered on Sep 14, 2019

The Cadillac battery saver feature activates when it senses a lower than normal battery voltage. This could be due to a alternator that is not charging or maybe a bad battery.
If you can get it started with a jump start, most auto parts stores will test battery and alternator for free.

Cadillac Cars &... | Answered on Sep 14, 2019

I would say YES, but Trail boss will look a lot better with 20inch tires

Cadillac Cars &... | Answered on Sep 13, 2019

first you have to see if theres an access panel there

Cadillac Cars &... | Answered on Sep 09, 2019

my crystal ball says it needs to be scanned before doing anything

Cadillac Cars &... | Answered on Sep 08, 2019

Pull the fuel pump fuse or the pcm fuse it will shut right off

2009 Cadillac... | Answered on Sep 06, 2019

Didn't it come with a wiring diagram? If you don't have a wiring diagram for your vehicle, don't do this yourself. You can really screw up things under the dash if you don't know what you're doing.

Cadillac Cars &... | Answered on Sep 06, 2019

Here is a diagram of the firing order.

2003 Cadillac... | Answered on Sep 01, 2019


How to Clean a Solenoid Starter in Cadillac Fleetwood car?

1) Keep the starter on a clean surface.
2) Clean the starter with lubricant cleaner.
3) Remove the motor from starter by removing the bolts holding the starter.
4) Clean the bolts also with the lubricant cleaner.
5)After the bolts are removed the stater will come out.
the inner cylinder connected to the starter will not come will remain in place.
6) Properly clean all the components with lubricant cleaner.
7) Use cleaning brush and rag to clean all the inner components.
8) The starter is cleaned now.
8) Then reassemble all the components back.
This will help.Thanks.

on Aug 31, 2019 | Cadillac Fleetwood Cars & Trucks

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cadillac Experts


Level 3 Expert

85161 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14727 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides