Connex Radio Communications - Page 6 - Recent Questions, Troubleshooting & Support


check the power switch contacts {ie do you get 13.8v at power on or after its fized a bit??? or roger bleep
pa circuit can do this also

Connex CX-4300HP... | Answered on Nov 23, 2014


There is something shorted in the power supply. See if you can get a schematic from their website. Most likely parts to check are the voltage regulators, protection diodes and capacitors. A shorted diode will go to ground too.

Connex 3300... | Answered on Nov 19, 2014


FOR ALL YOU MISS GUIDED FOLKS CONNEX IS NOT PART OF COBRA IN ANY WAY SHAPE OF FORM PERIOD ...CONNEX IS MADE BY RANGER U S A . AS FAR AS THE RECEIVE IT IS PROBABLY ARE MISSED SWITCH OR CONTROL NOT SET RIGHT SIR

Connex 3300... | Answered on Nov 08, 2014


get the mic away from both speakers

Connex... | Answered on Oct 04, 2014


If theres a Hi/LO and a/b/c/d/e/f . most are HI and a/d positions.

Connex 3300... | Answered on Sep 29, 2014


actually, non of them are, that radio is actually not legal on the CB service in the US

Connex 3300... | Answered on Sep 14, 2014


I'm assuming you mean just the knob, and not the shaft behind it, if it's a D shaped shaft, a slip of paper in the knob will tighten it up, if it's knurled and round shaft, spread the split in the middle open slightly until the knob is tight

Connex Radio... | Answered on Sep 14, 2014


This means that your swr is high. you can damage the radio using it in this condition, check antenna and coax for damage or misinstallation

Connex Cx-3600Hp... | Answered on Sep 14, 2014


PA transistor and/or driver transistor have failed

Connex 3300... | Answered on Sep 14, 2014


sounds like a power amplifier failure. have the rig serviced

Connex 3300... | Answered on Sep 14, 2014


you'll have to seperate the ground from the shield and then attach the rx,tx,and ground ,the shild then the ground thats on the shield.

Connex Radio... | Answered on Sep 11, 2014


could be in your finalwhere the problem exists.Try flexing your board by pushing down in the center to see if any noise comes through.

Connex Radio... | Answered on Sep 11, 2014


not really.Many radios come with one built into the meter on the radio. For those with none you will need an external SWR meter. I would recomend a trucker 2000.

Connex 4600 Base... | Answered on Aug 13, 2014


connex has ,I'm pretty sure , a 5 yr.warrenty.Go on their site and they will fix it for free.

Connex 3300... | Answered on Jul 23, 2014


probably sent enough power thru the reverse polarity diode to burd it but still have enough to keep lights on.

Connex Cx-366ce... | Answered on Jul 23, 2014


18 ft. you shouldn't have to worry because a 102 is carring a good match anyway.Make sure you use the good stuff and its not the skinny coax.

Connex Radio... | Answered on Jul 22, 2014


yes,but you want to make sure your antenna is tuneable.If your SWR is to high or to low you want to be able to adjust the antenna to bring the match up or down.Anything under a 1.9:1 is ok but the lower the better

Connex 3300... | Answered on Jul 22, 2014


The power cable for this is a standard one with red for +13.8v and black for 0v. The FC connector is for an external frequency counter.
Just because there are less wires than pins on a connector, does not mean there is a problem.

Connex 4300HP... | Answered on Jul 09, 2014


Is squelch turned too high that it is blocking too many signals?
Otherwise, it could be a faulty cable on the mic as the PTT button disconnects the speaker on the CB and a broken wire can cause the speaker to be disconnected.

Connex Cx-366ce... | Answered on Jul 09, 2014


You've been close to another big radio......you think that was a question but I believe it is the answer. The rf amp transitor or the diodes in that circuit have been damaged. So that stage of amplification is not stepping it up for the next. Resulting in the electrical power converted to air audio by speaker isnt available. Cb shops refer to this as a blow front end. Tr17 is the transistor location .......just a side note some radios have a mic circuit check that dulls audio levels this is not the case here.

Connex Cx-3600Hp... | Answered on Jun 14, 2014

Not finding what you are looking for?
Connex Logo

434 questions posted

Ask a Question

Usually answered in minutes!

Top Connex Radio Communications Experts

Chris

Level 2 Expert

197 Answers

Damon Nesselrodt
Damon Nesselrodt

Level 2 Expert

197 Answers

Ray Murphy

Level 2 Expert

68 Answers

Are you a Connex Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...