Dodge Logo

Dodge Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 796 Products
  • 329K Answers
  • 5M Views

1. Bad battery
2. Bad starter
3. Bad ground cable
4. Bad + cable
5. - eliminate these...if it doesn't start after checking/repairing/replace - repost.

Dodge Avenger... | Answered 7 hours ago


Hey Rhonda,
No, if it was snug against the cab it would rub, make noise, cause a rust point, etc..etc.. the bed must be sitting on the frame by itself..it allows flex and movement when it's loaded and when the truck's frame is tweaked while off roading.,, this couldn't happen if the bed was against the cab.
Hope this helps...

2008 Dodge Ram... | Answered 8 hours ago


Hello Steve Ma,

It is going to be UNDER the EVAP (cooler) coil...
where all the "cooling" should be taking place.

The result of "cooling" hot & soggy AIR is
(frost) condensation...

Working properly the ambient heat will keep the
EVAPORATIVE cooler from icing up (( and excess water will collect in the pan at the bottom ... ( LOOK there for a drain
hose )))... Directed straight out of the underside of your RAM...

Right above that WET SPOT on the pavement.

Happy hunting

https://en.wikipedia.org/wiki/Carnac_the_Magnificent

Dodge Ram 1500... | Answered 8 hours ago


With the correct tools, not too bad at all. In a driveway laying on the ground with jack stands, it can be a bit of a challenge, but doable.

2005 Dodge Ram... | Answered 10 hours ago


Check the fuse box in the engine bay.

Dodge Grand... | Answered 10 hours ago


You will need to diagnose the electrical systems, but I think I would start with the TIPM module. Check the connectors for corrosion on both sides.

Dodge Cars &... | Answered 13 hours ago


Here is a firing order diagram for that vehicle and engine, and let me know if you require any further assistance.


8ef43dd.jpg

1987 Dodge D150 | Answered 17 hours ago


You just made the single most common DIY mistake by replacing whatever part is listed in the trouble code. You didn't take the time to see that codes refer to a circuit malfunction. Check the fuse. If the fuse is good, get a wiring diagram and check for bad splices. You have a wiring problem, not bad sensors

P0141 O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 2)
P0161 O2 Sensor Heater Circuit Malfunction (Bank 2 Sensor 2)

Dodge Cars &... | Answered Yesterday


Did you clean the tank when replacing the fuel pump? Not cleaning the tank is the #1 cause or repeat fuel pump failures.

Dodge Cars &... | Answered Yesterday


If you are certain there is no filter, you will likely still have to get inside the blower housing. The next likely culprit would be the coil- it could be dirty and moldy. This may not be easy to access or see.
Also, make sure the drain hose isn't clogged- you should be getting water dripping under your car when the a/c is on, as it is removing the moisture in the air inside the vehicle.

Dodge Cars &... | Answered 2 days ago

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Dodge Caravan
2000 Dodge Caravan

2,240 Questions

1999 Dodge Durango
1999 Dodge Durango

-935 Questions

1999 Dodge Ram
1999 Dodge Ram

1,749 Questions

2000 Dodge Durango
2000 Dodge Durango

1,576 Questions

2005 Dodge Caravan
2005 Dodge Caravan

1,471 Questions

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Brad Brown

Level 3 Expert

18060 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...