Frigidaire Logo

Frigidaire Answered Questions & Fixed Issues

  • 3K Products
  • 135K Answers
  • 3M Views

Start simple. Check for the basic things that will not let the dryer run. Broken door switch. A loose wire on the door switch...those kinds of things. The same would apply to the start button. R

Frigidaire... | Answered 2 days ago | 25 views


There is some truth to it. Refrigerant needs to flow from high pressure to low pressure, and refrigerant pressure is directly proportional to temperature. Once the temperature drops below 40*F, for the outdoor coil, refrigeration efficiency is lost. Some heatpump units need auxiliary heat because.
Cold refrigerant condenses, into a liquid, and a compressor will not compress liquid, why its valves and internals would chatter into pieces. There is such thing as compressor crank case heaters, or belly band heaters. A heater removes, evaporates liquid refrigerant from within a compressor, it is protection.

I would get a compressor heater, wraps around the compressor belly, near 50 watts, and can use a relay to switch off the heater when the compressor runs, or let the heater work continuously.

Frigidaire... | Answered 3 days ago | 33 views


First take out the broiler pan, insert and any aluminum foil. Remove any other tools or pans from the oven. Next clean any large deposits in the oven cavity with hot, soapy water and a cloth. Clean the oven frame, the area outside of the door gasket and the very front center of the oven bottom with soap and water. Once you are ready to start the Self-Clean cycle, press the Self-Clean touch pad. To change the length of the Self-Clean cycle, press the pad again, as needed. Press Start. If you want to have the Self-Clean delayed, press the Delay Start touch pad after the Door Loc message appears. Type in the start time with the keypad.

To stop this cycle, press Cancel. If the oven is hot, the door will remain locked.

Frigidaire has most of their manuals available on their support site: http://b2b.frigidaire.com/support/manuals.asp . The current link to the English version of the Owner's manual is http://manuals.frigidaire.com/PDFnotFoundCheck.asp?path=ftp://ftp.electrolux-na.com/ProdInfo_PDF/&folder=Lassomption&PDFtype=Owner&PDFfile=318205312en.pdf&model=FGEW3045KFB . See pages 24-25 for this information.

I hope this helps.

Cindy Wells

Frigidaire Ovens | Answered on Nov 05, 2019 | 20 views


in don't know. perhaps the system resets itself. consider unplugging from electrical source. push start open and close.push stop if there is one to push. reconnect to power source.

Frigidaire... | Answered on Oct 29, 2019 | 39 views


unplug it and count to 10 and plug it back in.

If that doesn't work, remove the drain hose from its clips and lower the hose into a bucket. The unplug it and plug it back in. The water level switch also controls the door lock.

Frigidaire... | Answered on Oct 27, 2019 | 33 views


I DON'T KNOW. PERHAPS MOVING ARM UP AND DOWN A FEW TIMES - THEN UP AGAIN MIGHT
RESET CLICKER. IF NOT, TRY UNPLUGGING AT WALL AND MOVING ARM AGAIN.

Frigidaire... | Answered on Oct 26, 2019 | 32 views


sound like the condenser fan motor by the compressor has stopped and the not allowing the proper cooling check that also you should have waited at least 6 hr upright before starting the unit

Frigidaire... | Answered on Oct 23, 2019 | 344 views


call a repair service or go buy a new one

Frigidaire... | Answered on Oct 23, 2019 | 355 views


Its possible, the water valve will be energised to allow water to come in. The only way to confirm is to pull the fridge out and see if the noise is coming from where the water hose would normally be connected.

Frigidaire... | Answered on Oct 19, 2019 | 36 views


Microwaves are trapped within the oven cavity and do not enter the area outside of it. Metal reflects microwaves as does the mesh across the oven door. You can buy a strip of adhesive foam of reasonable density from your local hardware store which will serve the purpose.

Frigidaire... | Answered on Oct 18, 2019 | 60 views


The LED above the Ice Off icon should be lit when the icemaker is disabled. It should be off when you want ice from the icemaker. To toggle the setting, press and hold the Ice Off touch pad for 3+ seconds. This is shown in the manual for the FPHF2399MF2 on page 14. Sears Parts Direct has the manual here: https://www.searspartsdirect.com/manual/234cu4elin-001428/frigidaire-fphf2399mf2-bottom-mount-refrigerator .

I hope this helps.

Cindy Wells

Frigidaire... | Answered on Oct 18, 2019 | 51 views


Spider arms attached to stainless steel drum inside of tub have probably broken. This is a known problem with Frigidaire front loading washing machines. The stainless steel drum has a 25 year warranty but this does not include the spider arms. You cannot buy the spider arms separately, you have to buy the unit as one. The drum cost about $250.00 and probably about $300.00 in labor to install. You can do it yourself but it is pretty involved. Good Luck!

Frigidaire... | Answered on Oct 09, 2019 | 2,775 views


Possibly, the replacement EOC is defective.

Frigidaire Ovens | Answered on Oct 06, 2019 | 43 views


You are right! That is the most likely cause of the problem you described.

Frigidaire... | Answered on Oct 05, 2019 | 60 views


first try moving your drain hose higher it can cause this problem

Frigidaire... | Answered on Oct 04, 2019 | 1,057 views


If new and under warranty contact supplier. If you attempt to fix while under warranty and cause further faults then you may void warranty.

Frigidaire... | Answered on Oct 03, 2019 | 64 views

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Frigidaire Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Brad Brown

Level 3 Expert

18110 Answers

Cindy Wells

Level 3 Expert

6046 Answers

Are you a Frigidaire Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...