Funai Televison & Video - Recent Questions, Troubleshooting & Support


Where dose not firmware find Funai modal 29fl513/94

Funai Televison... | Answered on Mar 12, 2019


Hi, Based on your post/description, sounds like a mechanical problem with the take-up spool. As this would involve mechanical diagnosis and repairs, your best bet may be to seek the services of a qualified professional. Should you want to venture do-it-yourself, you need to remove the top cover and expose the inner mechanism of the VHS tape player. Of course the usual safety precautions when working with electrically powered devices. Once the inside mechanism is exposed, you will notice that there are 2 spools where the tape would be sitting when fully loaded. The right side is the take-up spool responsible for winding the tape when played or fast-forwarded. When fast forwarding during stop-mode it is direct gear driven however during play and fast-play, the take-up spool is driven by a clutch sandwiched between the top portion and the bottom wider portion. You need to disassemble the take-up spool. It may be held in place by hard press, force-fit, lock or retaining clip. Normally there is a spring near the top. Upon disassembly, you will notice the clutch which is a white fabric/cloth/cotton appearance. This has to be replaced. Probably available in eBay. In my location, such spare part is not readily available and we have to make do with work-around (not necessarily technically right but as long as it works and for your info only). Things we try:, Stretch the spring, the idea is to put more pressure on the clutch when assembled back; roughen the contact portion where the clutch mates with the spool assembly; worst case scenario, forget the clutch, dab a drop of rubber adhesive on both sides of the clutch. In certain models/versions, it is possible that a slipping belt is causing the problem. In some instances, it could be the driving motor. Hope this be of some help/idea. Post back how things turn up or should you need further information. Good luck and kind regards.

Funai PY90VG DVD... | Answered on Feb 25, 2019


UNFORTUNATELY THE INTERNAL HARD DRIVE HAS GONE BAD THAT IS THE TICKY TICK YOU HEAR

Funai PY90VG DVD... | Answered on Feb 08, 2019


THE SYMPTOMS YOU DESCRIBE ALMOST ALWAYS INDICATE A BAD MAINBOARD. (AKA THE GREEN BOARD INSIDE) AND RESULTING FROM FUNAI WALMART LOW GRADE COMPONENTS NOT BUILT TO LAST AND IN THIS CASE THE MAIN BOARD IS GOING BAD AND ITS ALMOST IMPOSSIBLE TO GET THE CORRECT REPLACEMENT BOARD THANKS TO WALMART AND FUNAI.

Funai MWC24T5 24... | Answered on Feb 08, 2019


YOUR USING AN OLDER STYLE SET OF CABLES AND ONE OF THEM IS BAD CAUSING THE MISSING COLORS.

IF YOUR UNIT SUPPORTS HDMI TRY AND HDMI CONNECTION THIS SHOULD SOLVE THE PROBLEM

Funai Emerson... | Answered on Feb 08, 2019


USUALLY THESE UNIT ONLY WILL WORK FOR ABOUT 50 COPIES THEN THE LOW GRADE LASER INSIDE BURNS OUT FROM THE HEAT PRODUCED AND NOT PROPERLY DISSIPATED AWAY FROM THE LASER MODULE.
WALMART FUNAI COMMON PROBLEM

Funai PY90VG DVD... | Answered on Feb 08, 2019


TRY THIS BUT ITS ONLY 50 PERCENT LIKELY TO WORK THESE UNITS ARE SPECIFICALLY FIRMWARED TO ONE REGION

https://www.youtube.com/watch?v=EdiJQBT2DPE

Funai PY90VG DVD... | Answered on Feb 08, 2019


BAD POWER SUPPLY BOARD IS USUALLY THE PROBLEM ON FUNAI WALMART. WHAT IS WORSE WALMART MAKES SURE U CANNOT GET PARTS TO FIX IT.

SOME ELECTRONIC SERVICE SHOPS CAN REBUILD BUT IS IT WORTH IT ON A FUNAI

Funai Televison... | Answered on Feb 08, 2019


TRY THIS BUT ITS ONLY 50 PERCENT LIKELY TO WORK THESE UNITS ARE SPECIFICALLY FIRMWARED TO ONE REGION

https://www.youtube.com/watch?v=EdiJQBT2DPE

Funai Televison... | Answered on Feb 08, 2019


quality issues with Walmart electronics aka Funai as well as dirty or worn out components from normal use on those models cause this condition. low grade unit usually will produce less than 50 copies in its lifetime before the heat generated by the laser destroys its self

Funai Televison... | Answered on Feb 08, 2019


funai is walmart but if your model
phone has the infrared programmable emulator most do not
  1. Connect your Android to the same WiFi Network.
  2. Download the Smart View App.
  3. Launch the Smart View App.
  4. Choose your TV and pairing.
  5. After connecting, select content from your Android that you want to enjoy on your Samsung TV.
  6. Control your Samsung TV.

Funai Televison... | Answered on Feb 08, 2019

Not finding what you are looking for?
Funai Logo

566 questions posted

Ask a Question

Usually answered in minutes!

Top Funai Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76140 Answers

Demonic-2011
Demonic-2011

Level 3 Expert

512 Answers

Jaime Hernandez

Level 3 Expert

2337 Answers

Are you a Funai Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...