Refrigerators - Answered Questions & Fixed Issues


Possibly evaporator fan motor is not working. Will show cold but as the air is not circulating, wi give these conditions. Call for service.

GE Refrigerators | Answered on Jul 13, 2019 | 36 views


GE lists this model as a 24.9 cu. ft. unit. https://www.geapplianceparts.com/store/parts/assembly/GSS25SGPASS .

I hope this helps.

Cindy Wells

GE Refrigerators | Answered on Jul 07, 2019 | 35 views


You've cleaned the condenser coil?

Common problem for the condenser coil to become clogged with dust and lint.

GE Refrigerators | Answered on Jul 01, 2019 | 71 views


I had the same problem. The cause is the digital display is not communicating with the motherboard. What had happened in my case is the plug connection between the door's digital display and the motherboard had become unplugged. The wire running from the motherboard runs below the fridge, and connects via plug located along the bottom of the fridge below the freezer door, connecting to the wire running from the display to the bottom of the freezer door. I just reconnected it and that reset the display. Glad for it too, I thought I needed a new $130 motherboard! Hope this helped!

GE Refrigerators | Answered on Jun 21, 2019 | 13,533 views


Check to see if the evaporator fan is working. It may be seized up and not blowing the cold air into the fridge compartment. Some GE have a air valve diverter which controls the air flow into the fridge. If the fan is working and there is no cold air into the fridge, this may be jammed in its closed position.

GE Refrigerators | Answered on Jun 16, 2019 | 73 views


This could be due to a faulty water sensor was the problem with mine

GE Refrigerators | Answered on May 31, 2019 | 339 views


Sounds like the drain hole is plug. Check it out. If it is then clean it.


Good luck

Mai

GE Refrigerators | Answered on May 28, 2019 | 49 views


Check that the plug your refrigerator is plugged into is not part of your GFCI circuit. If you have a plug that has a test/reset button on it (usually on the same wall, but not
necessarily) press the reset button and see if that doesn't help.

GE Refrigerators | Answered on May 28, 2019 | 45 views


GE lists the GTS22QBP as a 21.7 cu. ft. model. The specifications are available here: https://products.geappliances.com/appliance/gea-specs/GTS22QBPCC . (Note: the last two characters indicate the color of the refrigerator.) You can also get the specifications from the data sheet: https://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=310368.pdf .

I hope this helps.

Cindy Wells

GE GTS22QBP Top... | Answered on May 16, 2019 | 44 views


The wall separating the fridge and freezer section has tubing off the compressor called a mullion heater/ discharge tube heater. It is there to keep that strip slightly warm and prevent sweating during humid times. If it gets overly warm/hot to the touch then either it is due for a cleaning or the condenser fan has stopped. The defrost circuit is not the problem! After pulling the fridge out, remove the back panel and you will see a round condenser on the right hand side. The fan motor is mounted on the side of it. Clean as necessary and make sure the fan is running. Unplug during cleaning and protect your floor before pulling it out
g0310045-00008-43cnu3fiz4liqhfxokiai0k4-3-0.png

GE Refrigerators | Answered on May 12, 2019 | 46 views


Most modern refrigerators do not have defrost timers anymore. Instead, the main control board controls all of its functions. Older units would have a timer,much like a clock that would defrost every 6,8,or 10 hours if it needed it or not (some may have had a different time but these are the most common). With the main control, it will typically defrost every 8-10 hours of compressor run time. This cuts down on the cost to run it since the defrost cycle uses the most energy.

I am not sure why you are looking for this? you did not say what problem you are having but the main board is in the back, bottom right when you are looking at the back. You will see a rectangular metal plate with maybe 10 screws.
g1003138-00007-43cnu3fiz4liqhfxokiai0k4-3-0.png

GE Refrigerators | Answered on May 12, 2019 | 40 views


Failures of this type usually result in replacement of the ice maker assembly.

GE Refrigerators | Answered on Apr 29, 2019 | 286 views


https://www.helpowl.com/p/General%20Electric/GFSS6KIXSS/Research/25722

GE Refrigerators | Answered on Apr 08, 2019 | 48 views

Not finding what you are looking for?
GE Logo

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

Brad Goodale

Level 2 Expert

106 Answers

Peter Taylor

Level 2 Expert

119 Answers

Matt Sicignano

Level 1 Expert

7 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...