Gentron Electrical Supplies - Recent Questions, Troubleshooting & Support


Request the diagram from Gentron.

Gentron... | Answered on Sep 17, 2018


Hi!

We have a put together a guide here to assist you in these situations. It will guide you through testing, repairing and finding any parts you might need for the Generator. : https://www.generatorguru.com/need-help/
Regards,The Generator Guru Team

Gentron... | Answered on Aug 03, 2018


Plug gap is not hyper-critical. Too close is usually worse than too wide.
If you set the gap at .035 and the recommended gap is .025, it'll still run. Or set at .035 and recommended is .045.
We're talking about the thickness of 2-3sheets of paper difference.

Gentron 6000... | Answered on Jan 13, 2018


You've got an air leak somewhere. Running better with the choke closed is the clue. Air is entering somewhere else and by closing the choke you are basically adjusting the air/fuel ratio to be more correct.
With a combustible carb spray and red nozzle pipe, you can lightly spray around the carb as the engine runs and see where the running changes and that's your leak point. Keep the spray away from the carb inlet so you don't get misled.
The carb could also have gunked up gas deposits. Clean the carb also.
Re-check it.

Gentron 2800w... | Answered on Sep 15, 2017


You change the oil after used for a certain period of time. If not used often you do not change the oil as often as in a car. The manual you have will give you so called recommended intervals which in most cases are a tad too often.

Gentron... | Answered on Sep 04, 2017


https://www.google.com/search?client=aff-maxthon-maxthon4&channel=t27&q=gentron%20pro2%20generator%20welder%20manual

Gentron... | Answered on May 09, 2017


You must be more specific. Here's a link to a .pdf manual for A Gentron generator; perhaps you may find your generator manual within this thread.

http://www.searspartsdirect.com/partsdirect/user-manuals/GG3500-Gentron-GENERATOR-manual

Gentron... | Answered on May 09, 2017


Spray starting fluid into the engine air intake and see if that starts it, if that does then you have dried fuel clogging up the works.

Gentron... | Answered on Nov 23, 2016


Check the fuse. I had that happen and low and behold, changed out the fuse and poof! Works great. When plugging in cables / chords to an outlet on a gen make sure its dry, and has no dirt on it. (Look behind the control panel first for a fuse, may have the type that screws in and holds the fuse in place)

Gentron... | Answered on Aug 03, 2016


Check the position of on/off switches, and circuit breakers that may be interrupting the flow of current.

Gentron GG10020... | Answered on Apr 02, 2016

Not finding what you are looking for?
Gentron Logo

77 questions posted

Ask a Question

Usually answered in minutes!

Top Gentron Electrical Supplies Experts

Pieter Vleeshouwers
Pieter Vleeshouwers

Level 3 Expert

2009 Answers

Marvin
Marvin

Level 3 Expert

85161 Answers

TStevens

Level 2 Expert

110 Answers

Are you a Gentron Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...