Hotpoint Logo

Hotpoint Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 532 Products
  • 82K Answers
  • 2M Views

I had this problem and discovered it was due to a leak. The float switch attached to the bottom panel was operating. Pull out the mains plug, tip the machine on it's side (water will escape so get a mop ready), remove the bottom panel, 3 screws front and back, disconnect the connector from the float switch. Tape the connecter up out of the way and stand your machine back up. Try running it now. If you have a leak somewhere then you will get a puddle under the machine. If no leak, then I would suspect the float switch itself.

Hotpoint 24 in.... | Answered on Sep 14, 2019


From the information you have supplied, I suspect that the door interlock switch may be faulty. But without more information, it is difficult to be certain.
I hope this helps?

Hotpoint Washing... | Answered on Sep 10, 2019


Is it in demonstration mode ..... look at your instruction booklet to stop demonstration mode. They are similar but vary with model types and numbers.

Hotpoint Washing... | Answered on Sep 08, 2019


hi
sounds like the freezer part has an ice blockage the clicking may well be the fan chipping at ice and no air flow will mean the freezer is partialy working yey not allowing cold air to fridge
if this is the case to proove point give unit a good defrost for as long as possible then turn unit back on
if this works it will require a service engineer to check the defrost cycle of the unit is no longer failing
good luck

Hotpoint... | Answered on Sep 01, 2019


Unplug it from electric socket to see if that unlocks it.

Hotpoint Washing... | Answered on Aug 22, 2019


Check dryer door switch. Most common failure.

Hotpoint Dryers | Answered on Aug 18, 2019


clean the glass inner door @ the bottom. one strand of hair can cause it to leak. if that wont work inspect the bellows (door seal)

Hotpoint WMA32... | Answered on Aug 17, 2019


Avanb, I can almost assure you that the control board is the problem. I'm assuming that the interior lights are on, but no fans and the compressor is not running. To make sure, first unplug the temperature control harness. (encoder). If the refrigerator starts running, replace the temperature control board (encoder board. If it doesn't start running, replace the main board in back. To remove the control panel, remove the 2 screws located on the bottom. Slide the panel down. Then just disconnect the harness to the temperature control. Catriver.

Hotpoint... | Answered on Aug 07, 2019


Either the element has failed, or the fan has failed. There is a failsafe that if the fan fails, the element won't energize.

Hotpoint Ovens | Answered on Aug 03, 2019

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Hotpoint Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Brad Brown

Level 3 Expert

18072 Answers

Cindy Wells

Level 3 Expert

6004 Answers

Are you a Hotpoint Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...