Husqvarna Sewing Machines - Page 3 - Recent Questions, Troubleshooting & Support
Why does my Ruby shut down during a design
This is a design you have successfully sewn prior? Check available memory... go FileManager-> QuickHelp-> MyFiles, it will show available memory. Or could be the file is corrupt, load new copy into machine.
How minutes does it take to sew, design? I'm wondering if you have utility power issue<?>. May be try running machine off a properly sized UPS.
Or could be machine failure. May be try a different design file that you know worked prior.
on Mar 30, 2019
Viking 990s sewing machine
take needle back out hit the reset and this should realign back to center some machines have a 3 needle setup this is also a make sure that needle is positioned in middle
3 needle setup is for the thicker decrative sowing
on Mar 11, 2019
My Viking Rose sewing machine starts and stops and
The Rose has a sensor on the presser bar assembly that is giving you the grief. The machine thinkss the presser foot is in the raised position.There is a small metal flat spring that has gone bad and causing the error. Find an autorized service center to repair the problem.
on Mar 07, 2019
Foot pedal dead, machine keeps sewing!
There is no suppressor in the foot control of a 425. Only the control unit, which may need to be replaced. If the machine accelerates to full speed, it may have a problem with the "stop right" board which tells the machine whether to stop with the needle up.
You could have several problems, so go see a qualified Husqvarna repairman. You may contact Husqvarna customer service to locate the best one in your area.
on Feb 26, 2019
Why does my husqvarna viking 670 keep restarting everytime I press on the pedal. It was working for a few minutes then nothing
Rotate the handwheel several turns. It should turn smoothly and evenly without binding or jams.
Could be the problem is inside the foot control/cable. Disconnect foot control and try using START/STOP and see if the resets stop.
I noted the following in the manual;
"Never operate the sewing machine with any air openings blocked. Keep ventilation openings of the sewing machine and foot controller free from the accumulation of lint, dust, and loose cloth."
I don't believe this is your problem but check it anyway.
If it still resets when using START/STOP, could be speed control electronics inside machine or even the motor itself.
on Feb 06, 2019
Not finding what you are looking for?