Jeep Logo

Jeep Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 628 Products
  • 221K Answers

The only thing left is a broken wire it would have to be the alternator sense wire between the alternator #2 terminal and ECM terminal #40 find that wire and check to see if it has continuity you can use a DVOM or a test lite. I hope this helps. Take care.

Jeep Cars &... | Answered 17 hours ago

Take off the inside rear panel to access the latch. You can manually open it from there.

Jeep Cars &... | Answered Yesterday

One hour according to Motor Labor Manual .

Jeep Cars &... | Answered on Jul 15, 2019

Check the lockout switch for the windows. There is a lockout switch on the drivers door that will turn off all window functions in the car. Even the drivers controls.
Also after you have rulled that out, then try the window switches on each individual door.
If nothing is still working, I would try replacing the drivers switch assembly first. They are known problems. Just pay and change it. Be sure. Life is better this way.
Then change the motors in the doors if this does not cure it.
Also change the power lock motor in the failed door.
This will restore you to normal. Ebay is full of quality parts for your Jeep. I buy mine there on Ebay.

2002 Jeep Grand | Answered on Jul 15, 2019

When you are using the keyless entry you are flashing the turn signals... which are also the brake lamp filiment.
The park lamps on that side of the car simply dont work.
There is probably an open somewhere in the wire to that lamp. The lamps are fed through the wiring harness on the drivers side. Your break in the line is somewhere between the left and right in the rear. You can try to find it or run a jumper from left to right under the rug and save some pain. Your call.

2007 Jeep Grand... | Answered on Jul 15, 2019

Lift the hood. Behind each lamp up front under the hood you can see the sockets protruding out that hold the bulbs. Twist them and pull out. The lamps snap in. Make sure you have the AMBER coated lamps as replacements.
Headlamp bulbs are also accessible from this area.

2007 Jeep Grand... | Answered on Jul 15, 2019

there is a service bulletin about this problem. The fix is software and it is free. Call your Chrysler garage and schedule the recall service on the 4wd control module firmware.
This will solve the problem.
This is a relatively new fix within the last year or so.

2007 Jeep Grand... | Answered on Jul 15, 2019

When it don't want to start have a friend hit the gas tank while you try to start it, if it starts then it's your fuel pump

2005 Jeep Grand... | Answered on Jul 14, 2019

Most of that is not scheduled maintenance items. I would have your fuel filter replaced, if not done yet, it should be done every 20,000 miles. Alot of these places get a small commission for selling added services. I would go by the maintenance schedule in your owners manual.

2005 Jeep Grand... | Answered on Jul 14, 2019

If I may suggest, you may want to check the ignition coil or check your fuel pump. the most likely cause is that you have a bad pump, and it stopped working....causing you to only use the fuel in the lines and then the engine shuts off due to lack of fuel supply. have someone get close to the gas tank and listen for the fuel pump to cut on. Beforehand, it may be wise to check the fueses and relays for the pump.

2005 Jeep Grand... | Answered on Jul 14, 2019

Don't think its a 5.7 v8 but a 4.7. yes inline mounted on frame rail $33.00

Jeep Grand... | Answered on Jul 14, 2019

The problem I believe is the crank shaft position sensor.Check the wiring and make sure the connections are good.It is located at the right rear side of the engine block.Hope this helps.Good luck.

2005 Jeep Grand... | Answered on Jul 14, 2019

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts


Level 3 Expert

85108 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14707 Answers

Brad Brown

Level 3 Expert

18067 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides