Warning SCAM - DO NOT CALL THESE NUMBERS . These phony support numbers send you to criminal call centers where they will install malware, steal ID and/or extort money from you . Please only ever use the support contacts from the official company website
Warning SCAM - DO NOT CALL THESE NUMBERS. These phony support numbers send you to criminal call centers where they will install malware, steal ID and/or extort money from you . Please only ever use the support contacts from the official company website
Hi Amit Sharma, try replacing the two fuses that don't work
Replace them with fuses OF THE SAME VALUE, if you put more amperage, you run the risk of damaging your Panasonic Plasma TV TH42PZ700U
If you do not respond, look for a specialized technical service
Greetings Franco Dosil
Hola Amit Sharma, pruebe reemplazar los dos fusibles que no funcionan
Reemplacelos por fusibles DEL MISMO VALOR, si pone de mayor amperaje, corre el riesgo d3e perjudicar mas su TV Panasonic Plasma TH42PZ700U
Si no responde, Busque un servicio tecnico especializado
Saludos Franco Dosil
Those blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. http://electronicshelponline.blogspot.com/ Blinking codes details to many popular brand TVs are given. Surf the site with patience. If blinks continue without any pause, the main board is faulty. Counting of number of blinks to Philips TVs is entirely different to that of other brand TVs. It is not a direct count procedure. The site have details about how to count the number of LED blinks [Fault Codes] to Philips brand TVs are given; along with details of the faulty circuit location.
Software for NDDN-W56 is only available in Japanese if its in Japanese by default. if you want solution for ERROR" Please insert Correct Map CD" then post your email address here I will send you NDDN-W56 software Torrent for downloading along with instructions. 100% working on NDDN-W56
More than likely you have a bad circuit board behind the LCD. The LCD is the display itself. I've seen where someone did a bad job of soldering job, (cold solder joint created by flow soldering), at the factory. It may have passed quality control initially but one good hard bump and the 'cold solder' joint that was created at the company just got 'born.' It happens. Most of the time it's not a problem, but you will run across this every now and then. It looks like you 'then.' If it's still in warranty, take it back and ask for an exchange. If it's just past warranty, take it back anyway! Usually sellers understand and won't have a problem with an exchange.
Understand...It's not a user fixable thing!
The question is ambiguous from the standpoint of signal strength or television settings. If the signal strength drops the television wont do anything till it drops below a point that it pixelates. Then you will see big squares with blotches of color and the picture appears jerky. If that is not present, it is a good thing. The television settings are a matter of personal taste.