Reddy Logo

Reddy Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 40 Products
  • 2K Answers
  • 139K Views

...."I own one just like this and it is true at the beginning I did not know how to make the cold air work but once I play with the buttons everything worked fine. You have to press mode twice then press the minus button until the air gets cold. The instruction are not clear but the item is great, I used it year round." Prem air PCH1033 RC 1 8kw Ceramic Tower with Remote

Reddy HEATER... | Answered on Jul 23, 2019


is the sensor for the thermocouple located in the right spot in the flame,remove it and if you have access to a propane torch,heat the end till its red hot and leave it connected to the gas valve,then start the unit and this will tell you if the sensor is properly positioned in the pilot flame on the unit itself,if not you could have a defective new thermocouple or another safety device keeping it from staying lit or the gas valve is faulty

Reddy HEATER... | Answered on May 09, 2019


Jerry, you may have a low pressure output on the air pump behind the electric fan motor. There are 2 plastic plugs at the rear cover where the filter is. One is just a plug. If you have a low pressure air gauge say 10-20 psi max, you can remove this plug and screw it in that hole. Do not over tighten the gauge. The other plug increases air pressure when you turn it clockwise, counter clockwise to decrease. this model usually is set around 6 - 6.5 psi. If the pressure does not increase, it may be time to remove the rear pump cover and investigate the filters, rotor & carbon blades.

Reddy Heating &... | Answered on Jan 28, 2019


How to change Dearborn from natural to propane

Reddy Heater... | Answered on Jan 25, 2019


No it not, Sounds like the bushings are worn. It is time to replace motor. the part number is fasco 105336-01.

Reddy Heating &... | Answered on Jan 19, 2019


Possible the thermocouple bulb has slipped out of position and isn't being heated as it should. If it is a model with a pilot light, perhaps it is blocked.

The thermocouple is probably the most likely culprit.

Reddy Heating &... | Answered on Nov 12, 2018


Sears or Home Depot sell products and parts ... other than that.. hard to find

Reddy HEATER... | Answered on Jun 26, 2018


Fan operation should be less noisy after it has been replaced.

Reddy... | Answered on Jun 10, 2018


Read these troubleshooting tips. You must determine whether the failure is a fuel delivery problem or an electronics problem.
Reddy Heater troubleshooting tips

Good luck!

Reddy HEATER... | Answered on May 20, 2018

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Reddy Experts

jdthefixer

Level 3 Expert

746 Answers

Marvin
Marvin

Level 3 Expert

85161 Answers

Tom Chichester

Level 3 Expert

53777 Answers

Are you a Reddy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...