Roland Logo

Roland Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 453 Products
  • 5K Answers
  • 268K Views

It's usually fine to leave solid state electronic equipment turned on. A small amount of heat is produced when powered up and it will usually help to prevent condensation inside the case if that's a problem. It's not normally needed unless it's in a damp and/or cold environment. A dehumidifier is possibly a better solution if you have a lot of moisture.

Roland Music | Answered on Aug 18, 2019


Open up the Roland G-70 and check if all the connectors and flatcables are well seated. Check also if the power supply is working as supposed to.

Roland Music | Answered on Jul 26, 2019


0000007 eternal error

Roland SOLJET... | Answered on Jul 24, 2019


try easy cut studio from https://www.easycutstudio.com/
I've used it to cut a variety of vinyl decals using my own Roland GX-300 cutter and other artwork. It it completely compatible with my Roland GX-300 machine and very easy to use.

screen shot 2017-10-28 at 10.24.45 am-ray0nbkklnl1x1e5n12mjxoc-2-2.png

Roland GX-300... | Answered on Jul 10, 2019


ERROR 2:
Appears if the number of parameters differs from the permissible number.
You can download the EasyCut Pro software from https://www.easycutpro.com/ and give it a try.
This vinyl cutting software works great with Roland GX-300 CAMM-1 Pro Vinyl Cutter.

Roland GX-300... | Answered on Jul 10, 2019


If everything lights up and responds to button pushes like normal, and you've done a hard reset as described in the manual, check to see if you have sound out of the headphone jack. It's most likely not a user serviceable problem and will need to go to the shop, but it will probably be the output amp rather than the main board.

Roland Fp-8... | Answered on Jul 09, 2019


rtm yet, read the manual on it for "troubleshooting" pages?

Roland Music | Answered on Jun 27, 2019


It's always possible the new battery had lost it's charge before it was installed. Check it with an ohm meter for it's voltage. Other than that, either the contacts in the battery holder may be in need of cleaning or the battery wasn't installed correctly.

Roland Music | Answered on Jun 06, 2019


You don't tell us where you're located, but the best bet would be either Ebay, Craig's List, or Reverb.com

Roland Music | Answered on May 21, 2019

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Roland Experts

Andrew Taylor
Andrew Taylor

Level 3 Expert

28790 Answers

ray gallant
ray gallant

Level 3 Expert

63885 Answers

Tom Chichester

Level 3 Expert

53620 Answers

Are you a Roland Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...