Zodiac Pool Systems Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 21 Products
  • 10 Answers
  • 3K Views

turn off then back on

Zodiac Pool... | Answered on Oct 11, 2017


overheating check gas replace fuse might need chimney

Zodiac Pool... | Answered on Oct 03, 2017


turn off everything then control on then pump

Zodiac Pool... | Answered on Oct 03, 2017


see if gas ok replace pilot generator assembly and make sure no cobwebs in tubes

Zodiac Pool... | Answered on Oct 03, 2017


need more info does system have power to pump motor? if not check breaker if voltage from breaker check switch if you do have power to the pump motor sounds like bad pump motor

Zodiac Pool... | Answered on Apr 19, 2015


The thermostat could be defective

Zodiac Pool... | Answered on Aug 02, 2013


The axels are held on by a retainer attached with screws. I had a similiar problem with my polaris. Had to open up and locate the loose screws and re attach. Also the wheels are held on to the shaft with a c-clip. May be missing and the wheel fixin to come off

Zodiac Pool... | Answered on Dec 01, 2012


Check the following things that could be causing problems in these pool cleaners. If it is getting stuck on stairs, etc., first check the wheel RPM and make sure it is correct. Verify that the back up valve is cycling (lift the valve out of the water and watch the jet - it should come on and go off). Adjust your thrust jets if necessary. You might also have to install a ladder guard kit (part #G21).

One of these might also be causing in to not connect to the pool surface, but for this problem, you will also want to check the cleaner head and make sure that it is not full of water. Replace if it is.

Zodiac Pool... | Answered on Oct 12, 2010


It does not matter which wire goes to which post. As long as you put one on each and the ground wire on the green screw it will work fine. Be sure you select the proper voltage if your motor is dual rated. It must be set to match the line voltage present at the motor for it to work properly.

John

Zodiac Pool... | Answered on Oct 11, 2010

Not finding what you are looking for?

Zodiac Pool Systems Topics

Category:

Ask a Question

Usually answered in minutes!

Top Zodiac Pool Systems Experts

John Prohaska
John Prohaska

Level 3 Expert

1378 Answers

Tom Chichester

Level 3 Expert

53071 Answers

David Spradling
David Spradling

Level 3 Expert

10088 Answers

Are you a Zodiac Pool Systems Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...