Press enter to search.
Ross Keen posted an answer for this Coffee Makers & Espresso Machines:
"EA is a Krups model prefix but there is no EA250 in the worldwide service data I have..."
Ross Keen posted an answer for this Krups Coffee Makers & Espresso Machines:
"You can only get that wheel as part of the grinder, it is not possible to remove the burr..."
Ross Keen posted an answer for this Hobart Food Mixers:
"It sounds like either a partly stripped gear or a broken driving pin. If it is one of..."
Ross Keen posted an answer for this Krups Small Appliances Espresso Machine:
"You need to specify model, they are not all the same."
"Error 12 There was no pulse from the ejection switch so possibly a switch problem or worse..."
Ross Keen posted an answer for this KitchenAid Food Processors:
"Make sure you have the bowl, lid and sometimes the pusher assembled correctly. If..."
Ross Keen posted an answer for this KitchenAid Food Mixers:
"What you need to check is going to depend on the model. No point me attempting to help..."
Ross Keen posted an answer for this Vitamix Blenders:
"Check the black driving clutch on the top of the motor that engages with the other clutch..."
"If the thermoblock itself is the problem then I'd expect to read the element as open..."
"Try this, remove the tank, the drip tray, the bin on the side and the sliding thing above..."
"If it is assembled properly there is not a lot I can think of to cause that problem...."
"What do you call the planetary gear? The planetary hub is held on by a pin thru the shaft..."
"Make your espresso as normal with the exception that you keep holding down the button..."
"I'm not familiar with the model but I do know that you need to complete each and every..."
"If it is running too fast at start on low speed there are 2 likely causes. The speed..."
Ross Keen posted an answer for this Food Mixers:
"What model are we dealing with?"
"The heat sensor on the boiler is not detecting any temperature change. It could be a wire..."
"Error 9 is only related to the NTC on the front of the thermobloc. That's the wires,..."
"I make sure that the hole in the shaft is going to be in alignment with the hole in the..."
"Possibly something about either the lid or the bowl has become deformed. Very likely you..."
"There are three things it could be, the motor that drives the brewing unit, the brewing..."
"Error 05 I would normally associate with a distributor problem,
Ross Keen posted an answer for this Philips Food Processors:
"Debra that food processor is absolutely ancient, I doubt you'll get anything new for that..."
"Error code 01 accompanied by that noise points at the distributor being faulty. The..."
"Don't mess around with it and risk voiding your warranty, take it back to where you got it..."
"OA means that the sensor is not detecting any heat in the boiler. That means either the..."
"It would help if you told us the brand and model."
"The valve in the lid is faulty, it will eventually fail completely. The correct lid can be..."
"Check the carbon brushes and look for a broken or detached wire under the back cover."
"Husband will need to check the carbon brushes and make sure they aren't worn out. They are..."
"O sensor de temperatura na parte frontal da carca?a da caldeira (atr?s do painel ..."
Load more activity...
294,756 people helped
View all achievements