Press enter to search.
With access to plenty of resources
Steve Hurc posted an answer for this Isuzu Cars & Trucks:
"The engine ECU for a 4JJ1 engine is on inside of RHF guard"
"What country is the truck from & what is the VIN number & what system do you need...."
"no 2 different in years & engine"
"yes auto or manual vehicles must have the flex plate (Auto), flywheel (Man) installed in..."
"put key in ignition and turn to on position, engine not running, with door open. Then..."
"the radio has a fault. This is now an obsolete radio that cannot be repaired. You can..."
Steve Hurc posted an answer for this 2004 Isuzu Rodeo:
"so this engine should be an 6VE1, this has got shims on top of the valves. So best to go..."
"you should be fine with the standard genuine Isuzu tow bar. The rear of the vehicle may be..."
"main head bolts - 1st step-70NM, 2nd step-70NM, 3rd step-60-75 degrees turn angle, 4th..."
"ring Steve at North East Isuzu, he is technical support and can E-mail section of workshop..."
Steve Hurc posted an answer for this Holden Cars & Trucks:
"are you still needing the workshop manual?
if so I can help."
"square box on top of intake manifold"
"Neutral switch signal not changing on manual models
check Neutral switch on gear box for..."
Steve Hurc posted an answer for this 1998 Holden VT Commodore:
"no the code is not 1013
it should flash this same sequence 3 times (one flash small pause..."
"If door is in jammed state, open door by
repeatedly pressing the unlock button, while..."
Steve Hurc posted an answer for this Cars & Trucks:
"have seen mechanical issue inside steering box (balls that run on worm drive of input..."
"head bolts98 N?m (10 kg?m/72 lb?ft) ?147 N?m (15 kg?m/108 lb?ft) ? 30° - 60°
"if flywheel is fitted in correct position the timing mark on the front top cambelt gear is..."
"Valve Clearance Standard Value (cold)
Intake: 0.23 mm 0.33 mm (0.0091 in 0.0130 in)..."
Steve Hurc posted an answer for this 2004 Holden Astra:
"remove inside black plastic triangle pieces under carpet or service flap light assembly..."
"each tower should read about 6kilo ohms when measuring with multi meter from top to top of..."
"the rear pistons in the caliper have to be wound in while pushing on piston to reset worm..."
"it could have engine dammage or just that the exhaust is full of engine oil from old turbo..."
"no this wont make any difference"
"where the pipe from the intercooler goes onto inlet manifold rear left side"
"known issue take to holden dealer so they can update the software in the bcm
Steve Hurc posted an answer for this 2006 Holden Barina:
"are they using genuine pads?
have had aftermarket pads cause this"
"these had issues of not starting when cold and missfiring only when cold
this was due to..."
Steve Hurc posted an answer for this 1999 Holden VT:
"take it to an lpg repairer due to laws and regulations"
Load more activity...
271,615 people helped
View all achievements