Chrysler Cars & Trucks - Recent Questions, Troubleshooting & Support

After replacing the spark plugs in my 1999 Chrysler LHS with 3.5 engine I tried to start it and it has no spark to any of the plugs. I have power to all the coils but no spark in any of the 6.

Did you gap plugs?

Chrysler Cars &... | Answered 2 hours ago

2005 Chrysler 300 3.5 Was told computer is not sending out power to small wire that changes battery. Already replaced alternator. Will buying a reflashed pcm resolve those problems?

Yes, it should. Your voltage regulator is integrated inside of the ECU. Unfortunately, this part is paired to the vehicle VIN number and must be purchased from a dealership, then they will charge you to pair the new one to your vehicle before it will work.

Chrysler Cars &... | Answered 21 hours ago

1 Answer

How do i reset fob and anti theftin chrysler 300 2006

Tip & How-To about Cars & Trucks
Resetting a Vehicle Anti-Theft System
This is how you reset an anti theft system if you have the anti-theft light on, or your car is cranking, but you have no spark.

Doing a full reset of the anti-theft system.

Disconnect both battery leads for at least two hours.
Hold the negative and positive leads together for 5 minutes to fully discharge any power.
Put the key in the ignition, but not turned on. VERY IMPORTANT!
Connect the positive lead.
Connect the negative lead in one swift movement.
Wait 15 minutes for the system to fully reset.

Posted by Andrew... on Jan 14, 2018

Chrysler Cars &... | Answered 2 days ago

1 Answer

Remove drivers seat cup holder

yes...the console cover "plate" is a pop-off style..gentle persuasion w/a flathead screwdrive is all that is req'd..be sure to remove the shift knob 1st-there's am Allen wrench set screw holding that on, cuz that "plate may need to lifted off the shifter to have enough room

Chrysler 300M... | Answered on Dec 10, 2019

1 Answer

2005 Chrysler town and Country dvd player wont play

1. try to check the cable connected to your dvd player. make sure it doesnt loose and connected well
2. make sure that your dvd is well / can be used.
3. try to run another dvd to your dvd player. compare the result.
thanks.

Chrysler Cars &... | Answered on Dec 09, 2019

1 Answer

2013 chrysler 200 parking light wire location

Hi buddy,
Would suggest ya to try some online manuals.. if u know a good website then go ahead or otherwise try reliable-store.com
It's great for automobile repair and the people are also very helpful..
All the best:)

Chrysler Cars &... | Answered on Dec 05, 2019

1 Answer

What do I need to remove before I can change a freeze out plug on my chrysler seabring 2000 2.7 litre .

DEPENDS ON WHICH ONE YOU ARE WORKING ON AS TO WHAT IS IN THE WAY OF IT

Chrysler Cars &... | Answered on Dec 03, 2019

3 Answers

Why don't my wipers in my 2012 chrysler 200 work right?

There are lots of issues with the multifunction switch for Chrysler

2012 Chrysler... | Answered on Dec 02, 2019

2 Answers

I want to know where is the engine number found on the block of engine i know about the vin but i need to know where isit found on the engine

make year and model?

1999 Chrysler... | Answered on Dec 02, 2019

1 Answer

P0131 chrysler pacifika

Chrysler Pacifica P0131: O2 Sensor Low Voltage (Bank 1 -Sensor 1) P0131 is a common OBDII code that occurs in many vehicles, including the Chrysler Pacifica. It is letting you know that there is an issue with the wiring or harness going to the sensor, or the sensor itself is bad.Feb 1, 2019

Chrysler Pacifica P0131: O2 Sensor Low Voltage (Bank 1 ...

https://www.700r4transmissionhq.com > p0131-chrysler-pacifica

Chrysler Cars &... | Answered on Dec 01, 2019

3 Answers

Where is the ERG valve in a 2003 Chrysler 300m 3.5L engine?

The EGR valve is located at the rear of the engine, on the right side. The wiper arms, cowling and wiper transmission assembly all need to be removed to access the EGR.

Chrysler Cars &... | Answered on Dec 01, 2019

1 Answer

Code P0131

low voltage o2 sensor bank 1 sensor 1 the computer registered a fault that the o2 sensor had lasted over 2 minutes problem faulty o2 sensor --short in sensor/wiring--short in wiring circuit sensor 1 is the sensor before the cat converter

2004 Chrysler... | Answered on Dec 01, 2019

1 Answer