Ford Explorer Sport Trac - Answered Questions & Fixed Issues


Check your ASD . automatic shut down relay

2003 Ford... | Answered on Jan 07, 2020 | 156 views


check your owners manual, it will tell you. look for fuses in the index in the back of it.

2001 Ford... | Answered on Dec 29, 2019 | 79 views


Pull gently, but firmly. Scary at first. All late model Ford interior trim is the same.

Ford Explorer... | Answered on Dec 28, 2019 | 528 views


Headlights must be on for the interior trailer light to work.

2003 Ford... | Answered on Dec 28, 2019 | 78 views


Grease the linkage for the door holder spring.

2008 Ford... | Answered on Dec 28, 2019 | 118 views


check blower motor resistor.

2008 Ford... | Answered on Dec 24, 2019 | 172 views


May be the fuse there are separate ones for right and left headlights and DTRL'S OR ITS THE BULB OR THE PLUG FOR IT SOMETIMES THE BULBS GO INSIDE THE PLASTIC BASE AND YOU CAN'T SEE THAT IT'S BLOWN BECAUSE THE FILAMENTS INTACT

Ford Explorer... | Answered on Nov 13, 2019 | 34 views


Pull the instrument cluster out of the dash check all the connectors to it for loose pins and also take a look at the printed circuit on the back of the panel, look for any obvious problems. More than likely just pulling the connectors and reinserting them several times may cure this problem.

2005 Ford... | Answered on Oct 08, 2019 | 7,921 views


well search for leaks --check plugs for fouling -check coolant for oil mix -check trans for oil mix

2001 Ford... | Answered on Jun 29, 2019 | 26 views


go to rock auto.com look up your truck then in exhaust and emissions you will find the P.V.C. valve pictures so you will be able see where it is and the hose is there also

2010 Ford... | Answered on Jun 04, 2019 | 48 views


Removal
NOTE: The steps included in the SJB removal and installation procedure are critical to restoring the vehicle security and tire pressure monitoring systems to normal operation. A new SJB is delivered in manufacturing mode with 6 pre-set diagnostic trouble codes (DTCs) related to the tire pressure monitoring system. The presence of these DTCs requires the installation procedures be followed in order to clear the DTCs and enable normal SJB operations.
NOTE: Prior to the removal of the SJB, it is necessary to upload the module configuration information to the diagnostic tool. This information must be downloaded to the new SJB after installation. For additional information, refer to Section 418-01 .
  1. Remove the driver door scuff plate. For additional information, refer to Section 501-05 .
  1. Position the LH door opening weather seal aside.
  1. NOTE: While pulling the trim panel rearward, pull the hood release lever rearward in order for the release lever to slide through the trim panel. Remove the pushpin and the cowl side trim panel.
  1. Remove the 2 bolts and the parking brake release handle.
  1. Disconnect the parking brake switch electrical connector.
  1. Release the hood release cable pushpin from the parking brake control bracket.
  1. Release the harness clip from the parking brake cable housing.
  1. NOTE: Rotating the parking brake control counterclockwise allows enough access to clear the instrument panel reinforcement. Remove the 3 bolts and position the parking brake control assembly under the brake pedal.

Ford Explorer... | Answered on Apr 20, 2019 | 220 views


I don't have one for your truck but a quick trip to the junk yard with your cellphone camera will do it a picture says it all

2002 Ford... | Answered on Mar 27, 2019 | 44 views


the multi funtion switch is bad on the coulm

2001 Ford... | Answered on Mar 17, 2019 | 211 views


Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything
someone on fixya recommended it to me and I thank him even today
They have full manuals and it's verrrrry cheap and mine
I got free in offers
3rd time I bought it, I also had an issue with the file so the girl replaced it in 30 mins
there is one website more but i don't remember its name it was 2 years back bitman something link this
Try these out brother

2005 Ford... | Answered on Mar 15, 2019 | 60 views


Funny you ssked this wuestion cause my sisters showed the same codes and before you go spend $900 on a ABS MODULE and other parts check your wheel sensors and hubs the price difference is somewhere around $75 to $150 , i replaced her hub and this corrected the problem for her 2007 Explorer , i hope this info maybe helpful.

Ford Explorer... | Answered on Mar 08, 2019 | 219 views


here's a website that has all this information about all this and manuals everything totally free there are many actually but I personally like few .. let me know if u need help
thanks

2007 Ford... | Answered on Feb 07, 2019 | 144 views


the lock actuator i probably bad

2005 Ford... | Answered on Jan 18, 2019 | 54 views


250Nm or 184ft/lbs

2003 Ford... | Answered on Jan 15, 2019 | 93 views

Not finding what you are looking for?

-1,616 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...