2009 GMC Yukon XL - Answered Questions & Fixed issues


Break in the wire, and there may be 2 sensors in the engine. also check all your fuses under the hood. DO NOT run it with out knowing if you do have presure

2009 GMC Yukon... | Answered on Jun 08, 2015 | 59 views


I saw this answered by one user had same problem and they found one push rod did not have oil hole thru it RandR fixed his

2009 GMC Yukon... | Answered on Jan 23, 2015 | 88 views


I have cured just a few using a real AC Delco filter and synthetic 5w-30 oil. GM recommends using only 5w-30 oil in your engine because other weights can cause air to get into the lifters during start up and cause lifter noise.

2009 GMC Yukon... | Answered on Jan 23, 2015 | 161 views


The rear washer is fed from the same bottle that feeds the front washers! Normally the pipe comes off by the fuse box under hood! Lift hood and activate the rear washer.....if you hear the motor it's the pipe come off/blocked.....if no motor sound then it is the motor!

2009 GMC Yukon... | Answered on Dec 28, 2014 | 190 views


Warning system is working properly!

2009 GMC Yukon... | Answered on Mar 30, 2014 | 42 views


You need to be careful here. If you are driving your Vehicle with ZERO PRESSURE, you are going to blow up your engine.

There is also one of 2 other scenero's for a GM Vehicle

FIRST: Instrument Cluster STEPPER MOTORS are KNOWN to be going BAD in GM's/. If the Stepper Motor is bad, make sure you replace it with a X27.168

SECOND. Your Sending Unit could have come unplugged or the Unit itself went bad.

I am Betting that your Stepper Motor went bad (Happens that Frequently).

I would put a Gauge on the Motor and see what the Oil Pressure Actually is, if it is Truly ZERO... do not start or Drive the vehicle and take it to a Good Mechanic or if still under warranty.. To the DEALER

2009 GMC Yukon... | Answered on Apr 08, 2013 | 337 views


A mechanic would check for voltage and ground at the switch.

2009 GMC Yukon... | Answered on Aug 23, 2012 | 67 views


ride control has gone out and is in default mode.any time a problem is found it goes to this setting untill repaired. ride control module,ride sensors all need cked.

2009 GMC Yukon... | Answered on Aug 05, 2012 | 167 views


the cable that controls the mirror is more than likely broken or if it's gear driven the gear is stripped or broke. I would first try to take the switch apart and clean it

2009 GMC Yukon... | Answered on Jul 15, 2012 | 1,592 views


First off I believe you are using the incorrect weight oil. I am pretty sure you should be using 5w20 instead of 10w30. Check your owner's manual to be sure. At idle the oil pressure would be around 1/4 on the gauge and at highway speed it should read about 1/2. Make sure you are using a quality filter such as AC/Delco, Wix, or Purolator. If the oil pressure seems low is this vehicle not under warranty? If so, take it back to the dealer.

2009 GMC Yukon... | Answered on Jun 12, 2010 | 507 views


The oil needs to be drained from the gear box. If there is water in the transmission, you should probably change the oil in the front and rear axles and the transfer case. If the oil looks like a "milkshake"there is water in it. You will get most the water out in the first oil change, but drive it for a while after the first change and then change it again to get as much out as you can. You can do a ton of damage by driving a vehicle around like this, so don't put it off.

2009 GMC Yukon... | Answered on Mar 05, 2010 | 60 views


  • Rotate the hoist shaft counterclockwise in order to lower the spare tire to the ground. Continue to rotate the shaft until the spare tire can be pulled out from under the vehicle and removed. If the spare tire does not lower to the ground, the secondary latch is engaged causing the tire not to lower.
  • If the secondary latch is engaged and the cable end is visible, perform the following procedure: 3.1. Tighten the cable by rotating the hoist shaft clockwise until you hear 2 clicks or feel it skip twice. You cannot overtighten the cable. 3.2. Loosen the cable by rotating the hoist shaft counterclockwise 3 or 4 turns. 3.3. If the spare tire can be lowered, repeat steps 1 and 2 to see if the spare tire can be removed. 3.4. If the spare tire cannot be lowered, rotate the hoist shaft counterclockwise until approximately 15 cm (6 in) of cable is exposed. 3.5. Raise and support the vehicle. 3.6. Place a transmission jack, or equivalent, under the spare tire. 3.7. Position the center of the transmission jack under the secondary latch release button at the center of the spare tire. Arrange the arms of the transmission jack so they will support the tire after it has been released. 3.8. Raise the jack until the spare tire stops moving upward and is firmly held in place, releasing the secondary latch. 3.9. Lower the tire. If the spare tire is hanging by the cable, rotate the hoist shaft counterclockwise until the tire is low enough to remove.
  • 2009 GMC Yukon... | Answered on Nov 14, 2011 | 6,363 views


    You can try out some guide from here reliable-store. com

    they also provide live chat feature for instant help and it's very useful

    GMC Yukon XL... | Answered on Oct 02, 2019 | 22 views


    Short in the wiring or connector pins . Possible short in AC clutch .

    GMC Yukon XL... | Answered on May 17, 2018 | 44 views


    Visit the on-line store, known as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
    Best Manuals

    GMC Yukon XL... | Answered on Mar 15, 2018 | 30 views


    Can be done by a dealer or a shop

    GMC Yukon XL... | Answered on Jul 07, 2017 | 44 views


    The computer turns on the code when the signal is received from the TPS switch on the throttle body.

    GMC Yukon XL... | Answered on Jul 07, 2015 | 49 views


    Make sure trans fluid is full. See owners manual for proper dipstick test.

    GMC Yukon XL... | Answered on May 24, 2015 | 21 views

    Not finding what you are looking for?
    2009 GMC Yukon XL Logo

    32 questions posted

    Ask a Question

    Usually answered in minutes!

    Popular Products

    Top GMC Experts

    Marvin
    Marvin

    Level 3 Expert

    85216 Answers

    Jonah Oneal

    Level 3 Expert

    14092 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22485 Answers

    Are you a GMC Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...