20 Most Recent 2011 Chrysler Town and Country Questions & Answers


I have this problem with the backup camera, the dealership is telling me that the problem is in the TIPM (Totally Integrated Power Module). I am guessing there is a circuit board with a relay that went bad. They are telling me that the part is over $1000. I am going to check it out myself to be sure before fixing this.

2011 Chrysler... | Answered on Oct 15, 2018


You have remove Catalytic Converter and Engine mountes to get to the Starter.
This is the procedure

  1. Disconnect and isolate the negative battery cable.
  2. Remove the catalytic converter (3) See: Engine, Cooling and Exhaust\Exhaust System\Catalytic Converter\Service and Repair\Catalytic Converter - Removal.
  3. Remove the front engine mount through bolt.
  4. Remove the retainers (2) from the front engine mount bracket (1) and remove the bracket.
  5. Remove the field generator connector (1).
  6. Remove the B+ retainer (2) and B+ cable (3).
  7. Remove the stater retainers (1).
  8. Remove the starter (2).


I’m happy to assist further over the phone at https://www.6ya.com/expert/uttamjeet_2f3adc18600f8ede

2011 Chrysler... | Answered on Aug 28, 2017


Safety first, so begin by disconnecting the battery. Then lift your vehicle and place on jack stands. Then remove the few main wires that are attached to the starter. Make sure you label or make them so you know where they go once you are ready to hook them back up. Then, remove the bolts that hold it to the transmission. Once removed, reverse the procedure to install. Good luck

2011 Chrysler... | Answered on Dec 23, 2016


The first thing you do is have the battery tested, just because the lights come on doesn't mean the battery can run a starter which takes up to 100 amps. Any Autozone or other chain auto parts store will do the test for free.

2011 Chrysler... | Answered on Nov 10, 2016


The role of the crankshaft position sensor is to determine the position of the crankshaft, the crankshaft angle. It is usually with a camshaft position sensor work together - to determine the basic ignition timing. Car Diagnostic Tool

2011 Chrysler... | Answered on Aug 27, 2016


Slack in the ring and pinion gears, a bearing going bad. Transmissions can be rebuilt. Not necessary to replace it.

2011 Chrysler... | Answered on Aug 11, 2016


If the brake pedal pulsates while high speed braking, the rotors are warped/out of round. This can also produce noise as it can cause the caliper to move back and forth. You either have poor quality/cheap parts installed or the parts were installed with improper lube on the slide assemblies and there is dirt/rust causing the pins not to move freely or the pad shims are old and rusted causing the pads to stick and overheat the rotors. Have the brakes inspected for the source of the problem

2011 Chrysler... | Answered on Dec 29, 2015


My info says m28--10 amp, integrated power module, under the hood. Your owners manual may have fuse label and location. Sometimes the fuse-box lid has this information.
26021927-npdw0yzxi2o25hdscwaskwbz-4-0.jpg

2011 Chrysler... | Answered on Dec 25, 2015


I buy them, Rosemary. You can find them online, but you have to know what your looking and sift through everything it sends you. This takes time, even when you know. I buy them at Alldatadiy.com. $17.00 If I had yours, I would surely pass it on. I don't.

2011 Chrysler... | Answered on Sep 05, 2015


No video signal check camera for damage or something over lens also check cable behind bumper

2011 Chrysler... | Answered on Apr 22, 2015

Not finding what you are looking for?
2011 Chrysler Town and Country Logo

123 questions posted

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Town and Country Chrysler

  • Town and Country Chrysler

Most Popular Question

2011 t c liftgate stopped chiming when

  • Cars & Trucks
Loading...