Top 20 2007 Mitsubishi Galant Questions & Answers


The best way is to use a renter pressure bleeder, you may also need to have an ABS adapter tool to bleed it.

2007 Mitsubishi... | 44 views | 0 helpful votes


Radio has to come out & apart, to solder in new lamps

That's my guess

If the radio works & only the lights are out,then it is not a fuse issue

2007 Mitsubishi... | 61 views | 0 helpful votes


I would have your exhaust checked. You might have a plugged up catalytic converter. Most shops will flow test the cat for free.

Mitsubishi... | 33 views | 1 helpful votes


Could be a plugged fuel filter. You crank on it for a while and won't start, all the time pressure is building on the fuel against the blockage, you stop trying for a while. When you finally go back and crank on it some fuel has gotten past the blockage and it starts. Then will keep running because the fuel is now moving. If this isn't the case, after you replaced the fuel filter, then it isn't getting power to the fuel pump at first meaning there's something amiss in your fuel system. Possible an electrical sensor that tells the pump to come on when the switch is first activated.

Mitsubishi... | 31 views | 0 helpful votes


The best solution you'll get from books at www.reliable-store.com

These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicle- cars, atv, trucks. forklifts, boats, excavators etc.

Mitsubishi... | 301 views | 0 helpful votes


never heard of KICK starting a CAR

Mitsubishi... | 137 views | 0 helpful votes


At
www.reliable-store.com
get complete guide on whether to repair or
not, service it, and how to repair etc, along with wiring diagrams, electrical diagrams, torque specs, error codes, everything.

Mitsubishi... | 56 views | 0 helpful votes


The jerk is from misfire. Start at the top - check plugs or just put a new set in, check all coil packs and wiring, make sure you have correct fuel psi on fuel rails.

Mitsubishi... | 80 views | 0 helpful votes


The main fan probably has some big (10W) resistors on the fan motor support frame. What you describe sounds normal: A/C on requires much more air volume to be moved.

Your first step is to fix the crack in the radiator or replace it. While the rad is out, look at the fan. If the fan wiring harness has two wires, the fan is a single speed. If there's three or four wires, look for the 10W resistors, and check them with a meter. One may be burned out.

Mitsubishi... | 96 views | 0 helpful votes


Try swapping out the fan relay. It may be crapping out.

Mitsubishi... | 86 views | 0 helpful votes


I know this website www.reliable-store.com that i get manuals from, and they have all models online that solve all simple/technical problems
like professionals

I also brought for my 1989 BMW, such old model, they had it and it was very good manual. Go ahead, I bet.

Mitsubishi... | 25 views | 0 helpful votes


sounds like the fuel pump in the tank ? without seeing the vehicle myself i cannot tell you anymore .

Mitsubishi... | 46 views | 0 helpful votes


The usual cause of this is the lock has closed or jammed for some reason. You should be able to re-open the lock with the key or the lever inside the car. You should be able to see the lock mechanism is open.

The mechanism hooks on to the loop on the trunk edge. This loop is adjustable, and may have worked loose.

Lastly, all the above assumes that you have not had a rear end collision or similar damage.

Mitsubishi... | 54 views | 0 helpful votes


is your air flow meter hooked up good ? tight ? spray wd 40 around the manifold while engine is running did (engine) it speed up then you have a vacuum leak fix the leak with ultra grey silicone

Mitsubishi... | 34 views | 0 helpful votes


assuming your gearbox is automatic?
Either electrical or oil related.
Have you ever had the transmission oil an filters replaced?
Have you had a competent person hook up a compatable diagnostic test computer to your car for a read out?

I think these are your next steps.
Roger

Mitsubishi... | 24 views | 0 helpful votes


get help from the service and repair manual which will guide you to locate and fix the problem easily and to get the manual go to the given link http://toolsnyou.com/

Mitsubishi... | 32 views | 0 helpful votes

Not finding what you are looking for?
2007 Mitsubishi Galant Logo

15 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Galant Mitsubishi

  • Galant Mitsubishi

Most Popular Question

bench bleed master cylinder 2007

  • Cars & Trucks
Loading...